Dock traffic lights are red and green signals mounted outside and inside a loading bay to tell the driver and dock staff when it is safe to move or load. Interlocks are control links that stop equipment operating out of sequence, for example preventing the door opening until the trailer is restrained, or the leveller operating until the door is fully open.
Is this right for your site in Hampshire?
Sites around Hampshire that run night shifts often find traffic lights easier for drivers to read than staff waving or knocking on the cab door. Food and chilled operations around Hampshire with inflatable shelters often add interlocks so the shelter only inflates once a trailer is docked and restrained.
Loading docks in Hampshire where drivers wait in their cabs for a hand signal can replace guesswork with a clear red and green light at every bay.
Any project involving dock traffic lights and interlocks at a working site in Hampshire takes planning. We survey free of charge, quote a fixed price in writing, and then agree a programme that keeps as much of the dock running as possible. Specialist installation engineers carry out the work under our management, out of hours if that suits you better. On completion we test each item, show your team how it operates and leave the documentation with you.
Which interlocks should a loading bay have?
The most useful loading bay interlocks stop the door opening until the trailer is in place or restrained, and stop the leveller operating until the door is fully open. Beyond that, the right set depends on the equipment fitted and your risk assessment.
- Door to restraint: the door cannot open until the restraint is engaged or a trailer is detected.
- Leveller to door: the leveller cannot be raised until the door is fully open, which prevents the lip hitting door panels.
- Door to leveller: the door cannot close until the leveller is back in its parked position.
- Restraint release: the restraint only releases once the door is closed and the leveller parked.
- Shelter to trailer: an inflatable shelter only inflates when a trailer is docked.
On a bay without a restraint, a trailer presence sensor can take its place in the door logic, although it confirms a trailer is there rather than holding it. Combining interlocks with vehicle restraints gives the strongest protection against drive-away.
Can traffic lights and interlocks be added to older loading bays?
Yes, traffic lights and interlocks can be added to most older loading bays, although some need new control panels before the interlocks can work.
- Manual doors: a door position switch can confirm the door is fully open or closed, which lets lights and leveller interlocks work even without a motor.
- Older powered doors and levellers: basic control boxes may not have connections for interlocks, so a combined bay panel can replace separate controls.
- Mixed equipment: doors and levellers from different suppliers can usually be brought under one interlock panel, so every bay works the same way.
Interlocks cannot make faulty equipment safe. If a door or leveller has a defect, it should be repaired before interlocks are added, and the survey will flag anything we find. Upgrading lights and interlocks at the same time as replacing a door or leveller is often the most economical moment to do it.
Towns we cover in Hampshire
We take enquiries about dock traffic lights and interlocks from across Hampshire. These are the towns with their own pages:
- Southampton
- Portsmouth
- Basingstoke
- Gosport
- Waterlooville
- Farnborough
- Eastleigh
- Winchester
- Havant
- Andover
- Fareham
- Aldershot
- Fleet
- Totton
- New Milton
- Bordon
- Hythe
- Yateley
- Alton
- Emsworth
- Hedge End
- Bishopstoke
Budget range for supply and fit. The written quote after a free survey is the fixed price. All guide prices.
Regulations and approvals in England
Workplace safety in England is regulated by HSE. For a loading bay in Hampshire, that means doors meeting regulation 18 of the Workplace (Health, Safety and Welfare) Regulations 1992, equipment maintained under PUWER and suitable safeguards against vehicles driving away too early. We check what applies at survey and design the bay accordingly.
Questions
How long does installation take at a site in Hampshire?
It depends on the equipment, the number of bays, the condition of the dock and whether any building or electrical work is needed. We agree a programme with you after the survey, setting out which bays are out of use and when. Larger jobs are usually phased so that part of the dock stays open, and out-of-hours working can be arranged.
What details do you need from us to quote for dock traffic lights and interlocks?
To get started, send the site address in Hampshire, the number of bays or openings, approximate sizes, and photos of the dock from inside and outside. Tell us what vehicles you load, what goods you handle and any temperature requirements. Drawings help on new builds. We then arrange the free survey and confirm the details before the written quote is issued.
Which way round do the inside and outside lights work?
The inside and outside lights always show opposite colours. While a trailer is being loaded, the outside light is red so the driver stays put and the inside light is green so staff can work. When loading is finished and the door is closed, the inside light turns red and the outside light turns green for the driver.
Do traffic lights and interlocks need maintenance?
Yes. Lights, sensors and interlocks should be checked at each planned service visit, including testing the full sequence and confirming that steps attempted out of order are blocked. As part of the dock equipment they fall under PUWER, which requires work equipment to be maintained in a safe condition.
Other services in Hampshire
Full guide to dock traffic lights and interlocks · All loading bay services in Hampshire