A retractable dock shelter is a fabric shelter fixed to the building around a loading bay door, with flexible top and side curtains carried on a sprung or pantograph steel frame. When a trailer reverses in, the frame retracts and the curtains drape against the trailer's sides and roof, closing most of the gap while leaving the full width of the trailer opening clear for loading.
Why do sites in Lancashire choose this?
Docks facing open ground in Lancashire can catch rain driven sideways into the bay, which a well-fitted retractable shelter helps keep out. Retail and e-commerce distribution centres in Lancashire with high trailer turnover need tough sprung-frame shelters that recover quickly after each departure.
Shelter sizing for a bay in Lancashire starts with measuring the door and wall and recording the tallest, lowest and widest trailers you receive.
Your loading bay stays our responsibility from the survey to the handover. In Lancashire, the survey and written quote are free, and the quoted price is fixed for the agreed scope. Installation is carried out by specialist engineers working under our management, at times planned with you to protect your loading schedule. Out-of-hours work is available by arrangement. We finish by testing the equipment and handing over its documentation.
How do I size a retractable shelter for my trailers?
Size a retractable shelter to the largest trailer you receive, with a projection deep enough for opened trailer doors and the leveller lip, and curtains that still reach the smallest vehicles. The trailer mix sets almost every dimension.
- Width: wider than the trailer, so the side curtains drape along its sides rather than across the opening.
- Height: high enough for the tallest trailers, with a top curtain deep enough to reach the roof of the lowest.
- Projection: deep enough for the rear doors, folded back along the trailer sides, to sit inside the curtains.
- Curtain cut-outs: vertical slits let the side curtains wrap around hinges and rear fittings without tearing.
- Guide stripes: contrasting stripes on the curtains help drivers centre the trailer.
If your fleet is uniform, a seal may give a tighter fit. Our guide to shelters and seals sets out the trade-offs.
How can I stop dock shelter curtains being torn?
Most curtain damage comes from trailers reversing in off-centre or too far, so better guidance for drivers and correctly set bumpers prevent most tears. Worn curtains can then be replaced individually without changing the frame.
- Wheel guides: steel guides on the approach steer the trailer into the centre of the bay.
- Guide stripes and lights: high-visibility stripes on the curtains and dock lights help drivers line up.
- Bumpers: worn bumpers let trailers push too far into the shelter and strain the frame.
- Frame springs: weak springs leave the frame unable to retract and recover.
- Curtain grade: heavier fabric and reinforced edges last longer at busy docks.
Checking curtains, frame and fixings at each planned service picks up damage early, before a loose curtain starts flapping in the wind and tears completely.
Towns we cover in Lancashire
We provide retractable dock shelters right across Lancashire. Pick the town closest to your site from the list below.
- Preston
- Burnley
- Blackburn
- Blackpool
- Morecambe
- Lancaster
- Lytham St Annes
- Skelmersdale
- Leyland
- Accrington
- Chorley
- Darwen
- Thornton-Cleveleys
- Nelson
- Fleetwood
- Ormskirk
- Rawtenstall
- Colne
- Poulton-le-Fylde
- Heysham
- Haslingden
Budget range for supply and fit. The written quote after a free survey is the fixed price. All guide prices.
Which rules apply in England?
Workplace safety in England is regulated by HSE. For a loading bay in Lancashire, that means doors meeting regulation 18 of the Workplace (Health, Safety and Welfare) Regulations 1992, equipment maintained under PUWER and suitable safeguards against vehicles driving away too early. We check what applies at survey and design the bay accordingly.
Questions
Will you deal with building control and planning for a project in Lancashire?
We check at survey whether the work is likely to need approval. Forming a new opening or dock pit may need Building Regulations approval, a building warrant or building control approval, depending on the nation, and external structures such as loading houses can need planning permission. Where approval is needed, we explain what is involved, work with your designer or agent, and build it into the programme.
What warranty comes with new loading bay equipment?
New equipment comes with the manufacturer's warranty, which varies by product. Our workmanship terms are set out in writing in the quote for your Lancashire site, so you can see what is covered before you commit. Check the warranty terms for any servicing conditions, and we can quote for planned maintenance once the installation is complete.
Does a dock shelter keep a building warm?
A shelter reduces the draughts and rain entering the dock around a trailer, which helps keep the loading area warmer. It does not seal as closely as a dock seal or inflatable shelter, so for chilled and frozen docks those options are usually preferred.
Will a shelter work with curtain-sided trailers?
Yes, retractable shelters suit curtain-siders well, as the side curtains drape along the trailer body. Where curtain-siders are loaded from the rear, the shelter closes the gaps around the sides and roof while leaving the full rear opening clear for forklifts and pallet trucks.
Other services in Lancashire
Full guide to retractable dock shelters · All loading bay services in Lancashire