Loading bay doors and dock equipment, UK-wideFree site survey for new docks and upgradesRepair visits priced before we attend
Call free 0800 088 6248
Dock safety · York

Vehicle restraints in York

Our approach to vehicle restraints in York matches the way we work across North Yorkshire: understand the dock first, agree the scope in writing, then manage the job through to a tested handover.

Guide £4,200–£9,800 per bay ex VATFree site surveyYO1, YO10, YO31
Book a free survey0800 088 6248
Location
York, North Yorkshire
Main postcode districts
YO1, YO10 and YO31
Nearby (straight line)
Selby (12 miles), Harrogate (19 miles) and Goole (19 miles)
Survey and quote
Free, with a fixed written quote
Vehicle restraints, in short

A vehicle restraint is a device at a loading bay that physically holds a trailer against the dock until it is safe to leave. In the UK most systems act on the rear wheel, either as a powered wheel-based restraint or a sensor wheel chock. Restraints guard against early drive-away and trailer creep, and are usually interlocked with the door and dock traffic lights.

Is this right for your site in York?

Restraint systems for sites in York are surveyed, quoted and installed in the same way as anywhere else in the UK, with a fixed price set out in writing. New-build distribution sheds in York can have restraint rails and ducting planned into the yard slab from the start, which is simpler than cutting them in later.

A warehouse in York that already uses traffic lights may want to add restraints so the door cannot open until the trailer is physically held in place.

Here is what happens after you contact us about a site in York. We arrange a free survey, measure up and send a fixed written quote. If you go ahead, we manage the whole job, including ordering, delivery and coordination with your site team. Specialist installation engineers working under our management do the fitting, at times built around your loading schedule, with out-of-hours work by arrangement. Testing and handover documents close the job.

How does a vehicle restraint work with dock lights and interlocks?

A vehicle restraint is normally linked to the dock traffic lights and the door controls, so engaging the restraint is what allows loading to start.

A typical sequence looks like this:

  1. The trailer reverses on to the bay with the outside light on green and the door closed.
  2. The restraint engages the rear wheel. The outside light turns red for the driver and the inside light turns green for dock staff.
  3. The door can now be opened, and the leveller can only operate once the door is fully open.
  4. When loading is finished, the leveller is parked and the door closed before the restraint can release.
  5. The restraint releases, the outside light turns green and the driver can leave.

The exact interlocks depend on your equipment and risk assessment. See dock traffic lights and interlocks for the options on signals and control logic.

Wheel-based or hook restraint: which suits UK trailers?

Wheel-based restraints and sensor wheel chocks suit most UK trailers, because they act on the rear wheel rather than on the back of the vehicle. Hook restraints, which catch the rear impact guard (sometimes called an ICC bar), are common elsewhere but suit fewer UK fleets.

  • Wheel-based restraint: a steel guide rail fixed to the yard, with an arm or chock that moves against the rear wheel, either powered or pushed into place by the operative. It works regardless of tail lifts or underrun guard design.
  • Sensor wheel chock: a heavy chock placed in front of the wheel, with a sensor or parking station that tells the dock controls it is in position. Lower cost and minimal groundwork, but it relies on someone placing it each time.
  • Hook restraint: mounted on the dock face and hooking the rear guard. UK and European trailers vary widely at the rear, and tail lifts often get in the way, so this type needs checking against your actual fleet.
Guide price, York
£4,200–£9,800 per bay, ex VAT

The same published guide range applies across England; access, out-of-hours working and site conditions are confirmed at the free survey.

What does the free survey cover?

  • How often each door cycles during a typical shift
  • Wheel guide positions and yard markings for reversing vehicles
  • Asbestos register and any other site hazard information
  • Headroom above the opening and which track type will suit it
  • Wall and steel structure for door, shelter and bumper fixings
  • How drivers are prevented from pulling away too early

Options to discuss

Trailer support stands

Stands placed under the front of an uncoupled semi-trailer to stop it dropping or tipping as forklifts drive on, used alongside a wheel restraint or chock.

Sensor wheel chock

A heavy-duty chock with a sensor or parking station that tells the dock controls when it is in place. Minimal groundwork and suited to retrofit on existing bays.

Regulations and approvals in England

Workplace safety in England is regulated by HSE. For a loading bay in York, that means doors meeting regulation 18 of the Workplace (Health, Safety and Welfare) Regulations 1992, equipment maintained under PUWER and suitable safeguards against vehicles driving away too early. We check what applies at survey and design the bay accordingly.

Questions about vehicle restraints in York

Is the site survey in York free?

Yes. For new installations, replacements, upgrades, conversions and complete bays, the site survey and written quote are free and come with no obligation. The survey lets us measure the openings, check the dock and structure, and understand how the bay is used, so the quote reflects your site. Repair and servicing visits are different: they are chargeable, with the price agreed before anyone attends.

Can you work outside our normal operating hours in York?

Yes, by arrangement. Evening, night and weekend working can be planned so the installation causes as little disruption as possible to your loading schedule. Out-of-hours work can affect the price, so mention it at the survey and we will include it in the written quote. The agreed times are confirmed in the programme before the job starts.

Can you work alongside our main contractor on a new build in York?

Yes. For new warehouses and fit-outs, we can supply and install the dock package as part of a wider project, working to the main contractor's programme, site rules and permits. We will need drawings, dock levels and the programme, and we coordinate pit details, power supplies and door openings with the relevant trades before installation begins.

What happens if a powered restraint loses power?

Powered restraints are normally designed with a manual release so a trailer is not trapped on the bay if power is lost. Your site procedure should say who is allowed to use the release and what checks they make first. We explain the release method at handover.

Do vehicle restraints need servicing?

Yes. A restraint is work equipment under PUWER, so it must be maintained in a safe condition and inspected where wear could lead to danger. Servicing typically covers the rail and arm, sensors, controls and the interlock sequence with the door and lights.

Vehicle restraints near York

Distances are measured from York. Nearby towns we cover include Selby (12 miles), Harrogate (19 miles) and Goole (19 miles), and other towns in the area are covered too.

Other loading bay services in York

Full guide to vehicle restraints · Everything we do in York

Use the quote tool to tell us about the doors, levellers or shelters at your York site, and we will be in touch to arrange the next step.

Call freeGet a quote