- Location
- Bournemouth, Dorset
- Main postcode districts
- BH1, BH2 and BH7
- Nearby (straight line)
- Christchurch (4 miles), Poole (5 miles) and Ferndown (6 miles)
- Survey and quote
- Free, with a fixed written quote
A cold store dock door is an insulated loading bay door built for chilled or frozen buildings, usually a sectional door with thick insulated panels or a high-speed door with an insulated curtain. It differs from a standard dock door in its thermal breaks, extra seals and, on freezer docks, heating in the frame or seals so that ice cannot lock the door shut or tear the seals.
Is this right for your site in Bournemouth?
For a packhouse in Bournemouth handling fresh produce, a well-sealed chilled dock door helps keep warm air out of the store once produce has been cooled. Any cold store dock survey in Bournemouth is carried out with the store running, so we can see ice, seals and traffic as they really are.
Food manufacturers in Bournemouth moving finished product into frozen storage need doors that resist ice and close quickly behind each forklift or trailer movement.
If you are planning cold store dock doors for a site in Bournemouth, expect four stages. A free survey and fixed written quote come first. We then agree a programme with you, including any out-of-hours work. Specialist installation engineers carry out the installation under our management, with us as your single point of contact. Finally, the equipment is tested, your staff are shown how it works and everything is handed over with its documentation.
Do cold store dock doors have to meet building regulations?
Yes, a new or replacement cold store dock door is still a vehicle access door, so building energy rules apply alongside workplace safety law and product standards.
- England: Approved Document L (2021) Volume 2 limits the U-value of vehicle access and similar large doors to 1.3 W/m²K in new and replacement work. Cold store doors are normally specified to perform better than that to protect the store.
- Wales, Scotland and Northern Ireland: Approved Document L for Wales, Section 6 of the Scottish Building Standards Technical Handbook and Technical Booklet F2 in Northern Ireland apply. We confirm the figure for your nation and project.
- Power failure: under the Workplace (Health, Safety and Welfare) Regulations 1992 in Great Britain, or the 1993 Northern Ireland regulations, a powered door must be operable by hand where needed for health or safety, unless it opens automatically when power fails.
- Standards: BS EN 13241 for the door and BS EN 12453 for powered operation.
How can a cold store door be replaced without losing temperature?
A cold store door can be replaced with very little temperature loss if the work is planned around the store, with the opening screened and the fitting done in one continuous visit.
On a live cold store we usually:
- schedule the work for the quietest period, often overnight or at a weekend,
- fit a temporary insulated screen or strip curtain while the opening is exposed,
- remove ice from the old frame and threshold before fixing the new door,
- pre-assemble as much as possible so the opening is exposed for the shortest time.
From your side we need product moved back from the opening, any site permits for working in cold areas, and power for the operator and frame heaters. Heated frames typically need their own supply, which we set out in the quote. Our cold store loading bays guide covers planning the work in more depth.
The same published guide range applies across England; access, out-of-hours working and site conditions are confirmed at the free survey.
What we look at on site
- Lighting inside trailers and at the dock face
- Drainage on recessed or sloping dock approaches
- Wall and steel structure for door, shelter and bumper fixings
- Age and condition of the equipment already in place
- Access for deliveries, cranes or lifting equipment during installation
- How drivers are prevented from pulling away too early
Options to discuss
Insulated sectional cold store door
Thick insulated panels with thermal breaks and full perimeter seals, the usual choice for chilled and frozen external dock openings that also need to be secure overnight.
Heated frames and seals
Low-power heating in the side frames, bottom seal or threshold that keeps contact surfaces above freezing so the door does not ice up or tear its seals.
What do the rules in England mean for the work?
In England, Approved Document L (2021) sets a limiting U-value of 1.3 W/m²K for vehicle access and similar large doors in new and replacement work. That shapes door specification for sites in Bournemouth, so we confirm the requirement for your project and check what applies at survey before recommending a door.
Questions about cold store dock doors in Bournemouth
Which building and safety rules apply to a site in Bournemouth?
It depends on which UK nation the site is in. England and Wales use Building Regulations approval, Scotland uses building warrants and Northern Ireland uses building control approval from the council. Workplace safety is regulated by HSE in Great Britain and HSENI in Northern Ireland, and energy rules differ between nations. For your site in Bournemouth, we check what applies at survey and design to it.
How do you price cold store dock doors for a site in Bournemouth?
Guide budgets for supply and fit are £4,800 to £9,500 per door, excluding VAT. The figure moves with size, insulation, the operator, electrics, access, any pit or groundworks and out-of-hours working. Where levellers are involved, the guide assumes an existing, sound pit. After the free survey you receive a fixed written quote, and that is the price for the agreed scope.
Is the site survey in Bournemouth free?
Yes. For new installations, replacements, upgrades, conversions and complete bays, the site survey and written quote are free and come with no obligation. The survey lets us measure the openings, check the dock and structure, and understand how the bay is used, so the quote reflects your site. Repair and servicing visits are different: they are chargeable, with the price agreed before anyone attends.
What happens to a cold store door in a power cut?
In a power cut the door stops where it is and the frame heating switches off, so it must be possible to operate the door by hand. Powered dock doors normally have a hand chain, crank or release for this. We show your team how to use it at handover so the store can be closed up quickly.
Do heated door frames use a lot of power?
Frame and seal heaters are low-power elements designed to keep surfaces just above freezing rather than to heat the dock. Many can be controlled by a thermostat so they only run when needed. We set out the supply required in the written quote so it can be planned before installation.
Cold store dock doors near Bournemouth
Close neighbours of Bournemouth with their own pages here: Christchurch (4 miles), Poole (5 miles) and Ferndown (6 miles). Choose one to see coverage details for that town.
Other loading bay services in Bournemouth
Full guide to cold store dock doors · Everything we do in Bournemouth
Whether it is a new bay or a fault on an existing one, call us or request a quote for your site in Bournemouth.