- Location
- Bordon, Hampshire
- Main postcode district
- GU35
- Nearby (straight line)
- Alton (5 miles), Haslemere (7 miles) and Farnham (7 miles)
- Survey and quote
- Free, with a fixed written quote
A retractable dock shelter is a fabric shelter fixed to the building around a loading bay door, with flexible top and side curtains carried on a sprung or pantograph steel frame. When a trailer reverses in, the frame retracts and the curtains drape against the trailer's sides and roof, closing most of the gap while leaving the full width of the trailer opening clear for loading.
Why do sites in Bordon choose this?
If a shelter on an older unit in Bordon has a sound frame but torn, faded curtains, replacing just the curtains can be the economical choice. For a dock in Bordon where wide pallets need the full trailer opening, a shelter keeps that width clear while still closing the gaps.
Retail and e-commerce distribution centres in Bordon with high trailer turnover need tough sprung-frame shelters that recover quickly after each departure.
We keep the process simple for sites in Bordon. A free survey tells us what the dock needs; a fixed written quote tells you what it will cost and what is included. We then organise the installation, with specialist engineers under our management and a programme agreed around your shifts. Night and weekend work is available by arrangement. Before we leave, the new equipment is tested, demonstrated and handed over with its documentation.
How can I stop dock shelter curtains being torn?
Most curtain damage comes from trailers reversing in off-centre or too far, so better guidance for drivers and correctly set bumpers prevent most tears. Worn curtains can then be replaced individually without changing the frame.
- Wheel guides: steel guides on the approach steer the trailer into the centre of the bay.
- Guide stripes and lights: high-visibility stripes on the curtains and dock lights help drivers line up.
- Bumpers: worn bumpers let trailers push too far into the shelter and strain the frame.
- Frame springs: weak springs leave the frame unable to retract and recover.
- Curtain grade: heavier fabric and reinforced edges last longer at busy docks.
Checking curtains, frame and fixings at each planned service picks up damage early, before a loose curtain starts flapping in the wind and tears completely.
How do I size a retractable shelter for my trailers?
Size a retractable shelter to the largest trailer you receive, with a projection deep enough for opened trailer doors and the leveller lip, and curtains that still reach the smallest vehicles. The trailer mix sets almost every dimension.
- Width: wider than the trailer, so the side curtains drape along its sides rather than across the opening.
- Height: high enough for the tallest trailers, with a top curtain deep enough to reach the roof of the lowest.
- Projection: deep enough for the rear doors, folded back along the trailer sides, to sit inside the curtains.
- Curtain cut-outs: vertical slits let the side curtains wrap around hinges and rear fittings without tearing.
- Guide stripes: contrasting stripes on the curtains help drivers centre the trailer.
If your fleet is uniform, a seal may give a tighter fit. Our guide to shelters and seals sets out the trade-offs.
The same published guide range applies across England; access, out-of-hours working and site conditions are confirmed at the free survey.
Survey checklist for your dock
- Forklift and pallet truck loads crossing the leveller platform
- How drivers are prevented from pulling away too early
- How often each door cycles during a typical shift
- Traffic routes for vehicles and separation of pedestrians
- Drainage on recessed or sloping dock approaches
- Headroom above the opening and which track type will suit it
Options to discuss
Slit side curtains
Vertical cuts in the side curtains that let them wrap around trailer door hinges and rear fittings without tearing, extending curtain life.
Guide stripes
Contrasting high-visibility stripes on the curtains that give drivers a clear target to aim for when reversing onto the bay.
What do the rules in England mean for the work?
Powered doors and dock equipment installed in England may carry the UKCA or the CE mark, and doors are covered by the product standard BS EN 13241. We hand over the relevant documentation for each item fitted in Bordon. Planning and Building Regulations questions are never assumed either way: we check what applies at survey, so you know before work is booked.
Questions about retractable dock shelters in Bordon
Do you remove and dispose of the old equipment?
Yes, where it is part of the scope. When we replace doors, levellers, shelters or seals at a site in Bordon, removal and disposal of the old equipment can be included and is itemised in the quote, so it is clear what is covered. If anything should be kept, such as a frame or motor that is still serviceable, we agree that at survey.
Do you cover Bordon for retractable dock shelters?
Yes. We take on retractable dock shelters for businesses in Bordon and across Hampshire. We survey the site, provide a fixed written quote and manage the installation, with specialist installation engineers working under our management. Visits are arranged in advance at a time that suits your operation, and the same single contact stays with the job through to handover.
Will you deal with building control and planning for a project in Bordon?
We check at survey whether the work is likely to need approval. Forming a new opening or dock pit may need Building Regulations approval, a building warrant or building control approval, depending on the nation, and external structures such as loading houses can need planning permission. Where approval is needed, we explain what is involved, work with your designer or agent, and build it into the programme.
What projection should a dock shelter have?
Projection should be deep enough to clear opened trailer doors and hinges and to suit the leveller lip and bumpers. Shelters are commonly made with projections from around 500 to 1,000 mm, and we recommend a depth once we know your trailers and leveller.
Will a shelter work with curtain-sided trailers?
Yes, retractable shelters suit curtain-siders well, as the side curtains drape along the trailer body. Where curtain-siders are loaded from the rear, the shelter closes the gaps around the sides and roof while leaving the full rear opening clear for forklifts and pallet trucks.
Retractable dock shelters near Bordon
Distances are measured from Bordon. Nearby towns we cover include Alton (5 miles), Haslemere (7 miles) and Farnham (7 miles), and other towns in the area are covered too.
Other loading bay services in Bordon
Full guide to retractable dock shelters · Everything we do in Bordon
Ready to talk about a loading bay in Bordon? Call us, or send the details through the quote form.