Dock traffic lights are red and green signals mounted outside and inside a loading bay to tell the driver and dock staff when it is safe to move or load. Interlocks are control links that stop equipment operating out of sequence, for example preventing the door opening until the trailer is restrained, or the leveller operating until the door is fully open.
How does this suit sites in Norfolk?
Older docks in Norfolk with separate door and leveller controls can be brought into a proper sequence by adding interlocks that stop equipment working out of order. Whether your unit in Norfolk has one dock or twenty, the survey looks at each bay's existing controls before we quote a fixed price in writing.
If a site in Norfolk has had door panels damaged by levellers raised too early, a leveller-to-door interlock is a straightforward fix to consider.
We keep the process simple for sites in Norfolk. A free survey tells us what the dock needs; a fixed written quote tells you what it will cost and what is included. We then organise the installation, with specialist engineers under our management and a programme agreed around your shifts. Night and weekend work is available by arrangement. Before we leave, the new equipment is tested, demonstrated and handed over with its documentation.
How do inside and outside dock traffic lights work together?
Inside and outside dock lights always show opposite colours: when the driver sees red, dock staff see green, and the other way round. Each light is aimed at a different person, so each one only ever gives one instruction.
- Outside light, facing the driver: red means stay on the bay because loading is in progress; green means the bay is clear to leave or to reverse on to.
- Inside light, facing dock staff: green means the trailer is in place and it is safe to open the door and load; red means do not open the door or enter the trailer.
Lights can be switched in three main ways:
- Manually, by a switch beside the door, relying on dock staff to change it at the right moment.
- By door position, so opening the door automatically turns the outside light red.
- By the restraint, so the light only changes when the trailer is physically held.
Which interlocks should a loading bay have?
The most useful loading bay interlocks stop the door opening until the trailer is in place or restrained, and stop the leveller operating until the door is fully open. Beyond that, the right set depends on the equipment fitted and your risk assessment.
- Door to restraint: the door cannot open until the restraint is engaged or a trailer is detected.
- Leveller to door: the leveller cannot be raised until the door is fully open, which prevents the lip hitting door panels.
- Door to leveller: the door cannot close until the leveller is back in its parked position.
- Restraint release: the restraint only releases once the door is closed and the leveller parked.
- Shelter to trailer: an inflatable shelter only inflates when a trailer is docked.
On a bay without a restraint, a trailer presence sensor can take its place in the door logic, although it confirms a trailer is there rather than holding it. Combining interlocks with vehicle restraints gives the strongest protection against drive-away.
Towns we cover in Norfolk
We cover dock traffic lights and interlocks throughout Norfolk, and the towns below each have their own page. If yours is not listed, get in touch anyway.
Budget range for supply and fit. The written quote after a free survey is the fixed price. All guide prices.
Which rules apply in England?
Workplace safety in England is regulated by HSE. For a loading bay in Norfolk, that means doors meeting regulation 18 of the Workplace (Health, Safety and Welfare) Regulations 1992, equipment maintained under PUWER and suitable safeguards against vehicles driving away too early. We check what applies at survey and design the bay accordingly.
Questions
Do you remove and dispose of the old equipment?
Yes, where it is part of the scope. When we replace doors, levellers, shelters or seals at a site in Norfolk, removal and disposal of the old equipment can be included and is itemised in the quote, so it is clear what is covered. If anything should be kept, such as a frame or motor that is still serviceable, we agree that at survey.
Can you work alongside our main contractor on a new build in Norfolk?
Yes. For new warehouses and fit-outs, we can supply and install the dock package as part of a wider project, working to the main contractor's programme, site rules and permits. We will need drawings, dock levels and the programme, and we coordinate pit details, power supplies and door openings with the relevant trades before installation begins.
Can you add lights and interlocks across a whole dock in one project?
Yes. A whole-dock project is usually phased bay by bay so most doors stay in use, and every bay ends up on the same control standard. That consistency makes training easier for staff and drivers, and it simplifies servicing because every bay behaves in the same way.
Will interlocks slow down my loading operation?
Interlocks add a fixed sequence, but each step takes only moments and staff soon get used to it. In practice many sites find the sequence saves time overall, because there are fewer arguments about when to open the door and less damage from levellers being raised into part-open doors.
Other services in Norfolk
Full guide to dock traffic lights and interlocks · All loading bay services in Norfolk