- Location
- Dorchester, Dorset
- Main postcode district
- DT1
- Nearby (straight line)
- Weymouth (7 miles), Yeovil (18 miles) and Poole (20 miles)
- Visit pricing
- Agreed in writing before we attend
Dock shelter and seal repair covers restoring the weather seal around a docked trailer. Typical work includes replacing torn side and head curtains, worn foam seal pads and their covers, top pads and guide strips, repairing or replacing airbags and blowers on inflatable shelters, and straightening or replacing bent shelter frames, so the bay closes the gap between building and trailer again.
What should sites in Dorchester consider?
Older retractable shelters on estates around Dorchester can often be refurbished with new curtains and pads rather than replaced, provided the frame is still sound. Inflatable shelters at food sites in Dorchester depend on blowers and airbags working properly, and a slow-inflating shelter is worth checking before it fails.
If tenants change at a unit in Dorchester, checking the shelters and seals is sensible, because a new fleet may not suit the old curtain sizes.
Planned servicing and reactive repairs in Dorchester are both chargeable. We agree the price of each visit in writing beforehand, and we never extend the scope without asking. Photos taken by your team help us plan the work and the parts. The engineer records the condition of doors, levellers, shelters and safety equipment as they go, and you receive that as a written report after the visit.
Do dock shelters and seals fall under PUWER?
Yes. Dock shelters and seals are work equipment under the Provision and Use of Work Equipment Regulations 1998 (PUWER), so they must be suitable, maintained in a safe condition and inspected where deterioration could lead to danger. In Northern Ireland the equivalent is PUWER (Northern Ireland) 1999.
Shelter and seal damage is often treated as a comfort or energy issue, but some faults are safety issues too:
- loose head curtains, top pads or fixings that could fall;
- bent or broken frame arms with sharp edges at head height;
- wet or icy dock floors caused by gaps around the trailer;
- electrical faults on inflatable shelter blowers.
The regulator is HSE in Great Britain and HSENI in Northern Ireland. Including shelters and seals in planned maintenance, and recording what is found, shows they are being kept in a safe condition. Problems found during servicing are quoted as repairs before any work is done.
Why is my dock shelter or seal letting in draughts?
A dock shelter or seal lets in draughts when the material that should press against the trailer is torn, worn, too short or no longer in the right place. Daylight around a docked trailer is the clearest sign.
- Torn or shrunk curtains: side curtains no longer overlap the trailer sides.
- Short head curtain: taller trailers than the shelter was sized for leave a gap across the top.
- Flattened seal pads: foam that has lost its spring no longer closes the gap.
- Worn pad covers: exposed foam soaks up water and breaks down faster.
- Bent frame: a retractable shelter frame that no longer returns square.
- Airbag or blower fault: inflatable shelters that inflate slowly or lose pressure.
- Trailer position: off-centre parking or worn bumpers that let trailers crush one side.
On chilled docks, gaps also show up as condensation, ice on the dock floor or frost around the door.
The visit price is agreed before anyone attends. Parts and any extra work are quoted before they are fitted.
What we look at around the bay
- Dock bumpers for missing rubber or loose fixings
- Control panels, push buttons and emergency stops
- Safety edges, photocells and light curtains
- Vehicle restraint engagement and its signal sequence
- Door springs, cables and drums for wear or damage
- Lip hinge, lip extension and lip support operation
Options to discuss
Top pad and guide strip replacement
Renewing head pads, top seals and high-visibility guide strips that close the gap above the trailer and help drivers line up on the bay.
Curtain replacement
New side and head curtains for retractable shelters, made to measure in hard-wearing coated fabric, with slits and overlaps set to suit the trailers you receive.
Planning, building control and safety law in England
Powered doors and dock equipment installed in England may carry the UKCA or the CE mark, and doors are covered by the product standard BS EN 13241. We hand over the relevant documentation for each item fitted in Dorchester. Planning and Building Regulations questions are never assumed either way: we check what applies before any work starts, so you know before work is booked.
Questions about dock shelter and seal repairs in Dorchester
What information helps before a repair visit?
Photos or a short video of the fault are the most useful thing you can send, along with the make and model from the data plate, a description of what happens when the equipment is operated and any error codes. For a site in Dorchester, also tell us about access, parking and site rules. With that, we can price the visit and bring the likely parts.
What is the difference between servicing and a statutory inspection?
Servicing keeps equipment working: cleaning, adjusting, lubricating and replacing worn parts. A statutory inspection or thorough examination is a separate check by a competent person, often arranged through your engineering insurer. Dock levellers are commonly inspected under PUWER at 12-month intervals, and lift tables may need LOLER thorough examination, depending on the equipment and how it is used. Your insurer or competent person will confirm what applies.
How often should equipment at our Dorchester site be serviced?
It depends on how hard the equipment works and on the manufacturer's recommendations. A multi-shift dock with frequent trailer movements needs more attention than a door that opens a few times a day. We suggest a schedule after looking at the equipment and how it is used, and we can line visits up with your insurance inspections where that helps.
Can worn dock seal covers be replaced without new foam?
Often, yes. If the foam inside a seal pad still springs back, a new cover can be fitted over it. If the foam has stayed compressed or soaked up water, the pad is usually replaced complete. Photos of the pads, front and side, help us judge which applies.
Can you replace just the curtains on a dock shelter?
Yes. If the frame is still sound, the side and head curtains can be replaced on their own, which is the most common shelter repair. Curtains are usually made to measure, so the shelter is measured first and the new curtains fitted on a second visit, with both visits priced in advance.
Dock shelter and seal repairs near Dorchester
Close neighbours of Dorchester with their own pages here: Weymouth (7 miles), Yeovil (18 miles) and Poole (20 miles). Choose one to see coverage details for that town.
Other loading bay services in Dorchester
Full guide to dock shelter and seal repairs · Everything we do in Dorchester
Request a quote for your loading bay in Dorchester, attaching photos of the dock, the equipment and any damage.