- Location
- Poole, Dorset
- Main postcode district
- BH15
- Nearby (straight line)
- Bournemouth (5 miles), Wimborne Minster (5 miles) and Ferndown (7 miles)
- Visit pricing
- Agreed in writing before we attend
Dock shelter and seal repair covers restoring the weather seal around a docked trailer. Typical work includes replacing torn side and head curtains, worn foam seal pads and their covers, top pads and guide strips, repairing or replacing airbags and blowers on inflatable shelters, and straightening or replacing bent shelter frames, so the bay closes the gap between building and trailer again.
Is this right for your site in Poole?
Curtains tearing at the corners at docks in Poole can be a sign that taller or wider trailers are arriving than the shelter was sized for. Multi-bay sites near Poole often find several shelters in similar condition, so measuring and replacing curtains across the dock in one programme can reduce costs.
If tenants change at a unit in Poole, checking the shelters and seals is sensible, because a new fleet may not suit the old curtain sizes.
Every visit to a site in Poole begins with an agreed price. The charge is confirmed in writing before an engineer attends, so the cost is clear from the outset. Photos of the fault, the data plate and the surrounding area make diagnosis easier. Extra work found during the visit is priced and approved before it is done. A written report then sets out what was found, what was fixed and what still needs attention.
How can I make shelter curtains and seal pads last longer?
Shelter curtains and seal pads last longest when trailers arrive straight, stop at the right distance and the parts are checked regularly. Most premature damage comes from how trailers are parked rather than from the material itself.
- Wheel guides: keep trailers centred so they do not drag one side curtain or crush one pad.
- Bumpers: worn bumpers let trailers reverse too far in and over-compress seals.
- Guide markings: clear centre lines on curtains and the dock help drivers line up.
- Early repairs: a small tear repaired early is cheaper than a full curtain later.
- Wear-resistant facings: seal pads can be specified with tougher covers where trailers rub most.
- Blower care: keeping blower intakes clear helps inflatable shelters inflate fully.
Our loading bay servicing includes shelters and seals, so wear is picked up alongside doors and levellers.
Why is my dock shelter or seal letting in draughts?
A dock shelter or seal lets in draughts when the material that should press against the trailer is torn, worn, too short or no longer in the right place. Daylight around a docked trailer is the clearest sign.
- Torn or shrunk curtains: side curtains no longer overlap the trailer sides.
- Short head curtain: taller trailers than the shelter was sized for leave a gap across the top.
- Flattened seal pads: foam that has lost its spring no longer closes the gap.
- Worn pad covers: exposed foam soaks up water and breaks down faster.
- Bent frame: a retractable shelter frame that no longer returns square.
- Airbag or blower fault: inflatable shelters that inflate slowly or lose pressure.
- Trailer position: off-centre parking or worn bumpers that let trailers crush one side.
On chilled docks, gaps also show up as condensation, ice on the dock floor or frost around the door.
The visit price is agreed before anyone attends. Parts and any extra work are quoted before they are fitted.
Checks made while we are on site
- Traffic light function and interlock operation
- Shelter curtains, frames and side pads for tears
- Vehicle restraint engagement and its signal sequence
- Inflatable shelter fans, airbags and control function
- Safety edges, photocells and light curtains
- Door springs, cables and drums for wear or damage
Options to discuss
Seal pad refurbishment
Replacing worn foam pads, or just their covers where the foam is still sound, including tougher facings on the areas where trailers rub most.
Airbag and blower repairs
Repairing or replacing torn airbags, failed blower motors and controls on inflatable shelters so the bags inflate fully and seal around the trailer again.
Planning, building control and safety law in England
Powered doors and dock equipment installed in England may carry the UKCA or the CE mark, and doors are covered by the product standard BS EN 13241. We hand over the relevant documentation for each item fitted in Poole. Planning and Building Regulations questions are never assumed either way: we check what applies before any work starts, so you know before work is booked.
Questions about dock shelter and seal repairs in Poole
Can you repair all makes of loading bay equipment?
We work on common makes and types of doors, dock levellers, shelters, seals and restraints. Parts availability varies, particularly for older or discontinued equipment, so it helps to send the make, model and photos of any data plates from your site in Poole. If original parts are not available, we tell you and price the alternatives, including replacement where that makes more sense.
Do you cover Dorset for dock shelter and seal repairs?
Yes. We take on dock shelter and seal repairs for sites in Poole and throughout Dorset. Each visit is arranged in advance, with the price agreed in writing before anyone attends. Specialist service engineers working under our management carry out the work, and we remain your point of contact from the first call to the written report.
What happens if the engineer finds the equipment unsafe?
If equipment is found to be unsafe, the engineer will tell you straight away and recommend that it is isolated and taken out of use until it is repaired. That is recorded in the written report. We then quote the repair so you can decide how to proceed. Keeping an unsafe door or leveller in service puts people at risk, so we will always raise it.
Why do shelter curtains keep tearing?
Shelter curtains usually keep tearing because trailers arrive off-centre, the curtains are too short or tight for the trailers now in use, or worn bumpers let trailers reverse too far in. Fixing the cause, for example with wheel guides or resized curtains, stops repeat damage.
Can worn dock seal covers be replaced without new foam?
Often, yes. If the foam inside a seal pad still springs back, a new cover can be fitted over it. If the foam has stayed compressed or soaked up water, the pad is usually replaced complete. Photos of the pads, front and side, help us judge which applies.
Dock shelter and seal repairs near Poole
Businesses outside Poole may find their nearest town in this list: Bournemouth (5 miles), Wimborne Minster (5 miles) and Ferndown (7 miles). Each page covers doors, docks, repairs and servicing.
Other loading bay services in Poole
Full guide to dock shelter and seal repairs · Everything we do in Poole
Request a quote for your loading bay in Poole, attaching photos of the dock, the equipment and any damage.