Loading bay doors and dock equipment, UK-wideFree site survey for new docks and upgradesRepair visits priced before we attend
Call free 0800 088 6248
Dock safety · Exmouth

Vehicle restraints in Exmouth

Our approach to vehicle restraints in Exmouth matches the way we work across Devon: understand the dock first, agree the scope in writing, then manage the job through to a tested handover.

Guide £4,200–£9,800 per bay ex VATFree site surveyEX8
Book a free survey0800 088 6248
Location
Exmouth, Devon
Main postcode district
EX8
Nearby (straight line)
Exeter (9 miles), Newton Abbot (11 miles) and Torquay (12 miles)
Survey and quote
Free, with a fixed written quote
Vehicle restraints, in short

A vehicle restraint is a device at a loading bay that physically holds a trailer against the dock until it is safe to leave. In the UK most systems act on the rear wheel, either as a powered wheel-based restraint or a sensor wheel chock. Restraints guard against early drive-away and trailer creep, and are usually interlocked with the door and dock traffic lights.

What should sites in Exmouth consider?

Third-party hauliers visiting sites in Exmouth may not know each site's procedures, so a restraint that holds the wheel removes reliance on every driver following instructions. New-build distribution sheds in Exmouth can have restraint rails and ducting planned into the yard slab from the start, which is simpler than cutting them in later.

A warehouse in Exmouth that already uses traffic lights may want to add restraints so the door cannot open until the trailer is physically held in place.

Here is what happens after you contact us about a site in Exmouth. We arrange a free survey, measure up and send a fixed written quote. If you go ahead, we manage the whole job, including ordering, delivery and coordination with your site team. Specialist installation engineers working under our management do the fitting, at times built around your loading schedule, with out-of-hours work by arrangement. Testing and handover documents close the job.

How does a vehicle restraint work with dock lights and interlocks?

A vehicle restraint is normally linked to the dock traffic lights and the door controls, so engaging the restraint is what allows loading to start.

A typical sequence looks like this:

  1. The trailer reverses on to the bay with the outside light on green and the door closed.
  2. The restraint engages the rear wheel. The outside light turns red for the driver and the inside light turns green for dock staff.
  3. The door can now be opened, and the leveller can only operate once the door is fully open.
  4. When loading is finished, the leveller is parked and the door closed before the restraint can release.
  5. The restraint releases, the outside light turns green and the driver can leave.

The exact interlocks depend on your equipment and risk assessment. See dock traffic lights and interlocks for the options on signals and control logic.

How much does a vehicle restraint cost?

A vehicle restraint typically costs £4,200 to £9,800 per bay, supplied and installed, excluding VAT. Sensor wheel chocks linked to the dock controls usually sit towards the lower end, and fully automatic wheel-based restraints with rail and interlocks towards the upper end.

What moves the price:

  • Restraint type: a sensor chock needs far less hardware and groundwork than a powered, rail-mounted wheel restraint.
  • Yard condition: rail-mounted units need a sound, level concrete apron. Broken concrete or tarmac may need a new base, priced after survey.
  • Cabling: the distance from the restraint to the dock control panel, and whether ducts must be cut into the yard.
  • Integration: linking to existing door and leveller controls is simpler on modern panels; older panels may need replacing.
  • Number of bays and working hours: several bays in one project spread set-up costs, while out-of-hours work adds cost.

All figures are guide budgets. After a free site survey we send a written quote, and that quote is the fixed price. VAT is added at the standard rate.

Guide price, Exmouth
£4,200–£9,800 per bay, ex VAT

The same published guide range applies across England; access, out-of-hours working and site conditions are confirmed at the free survey.

Survey checklist for your dock

  • Whether planning, building control or a building warrant may be needed
  • Control positions, isolators and any existing interlocks
  • Wall and steel structure for door, shelter and bumper fixings
  • Drainage on recessed or sloping dock approaches
  • Traffic routes for vehicles and separation of pedestrians
  • Headroom above the opening and which track type will suit it

Options to discuss

Sensor wheel chock

A heavy-duty chock with a sensor or parking station that tells the dock controls when it is in place. Minimal groundwork and suited to retrofit on existing bays.

Manual wheel-based restraint

The same rail-mounted principle with the restraint pushed into position by the operative. Lower cost than a powered unit, with a sensor to confirm engagement to the controls.

What do the rules in England mean for the work?

Powered doors and dock equipment installed in England may carry the UKCA or the CE mark, and doors are covered by the product standard BS EN 13241. We hand over the relevant documentation for each item fitted in Exmouth. Planning and Building Regulations questions are never assumed either way: we check what applies at survey, so you know before work is booked.

Questions about vehicle restraints in Exmouth

Will you deal with building control and planning for a project in Exmouth?

We check at survey whether the work is likely to need approval. Forming a new opening or dock pit may need Building Regulations approval, a building warrant or building control approval, depending on the nation, and external structures such as loading houses can need planning permission. Where approval is needed, we explain what is involved, work with your designer or agent, and build it into the programme.

Is the site survey in Exmouth free?

Yes. For new installations, replacements, upgrades, conversions and complete bays, the site survey and written quote are free and come with no obligation. The survey lets us measure the openings, check the dock and structure, and understand how the bay is used, so the quote reflects your site. Repair and servicing visits are different: they are chargeable, with the price agreed before anyone attends.

How do you price vehicle restraints for a site in Exmouth?

Guide budgets for supply and fit are £4,200 to £9,800 per bay, excluding VAT. The figure moves with size, insulation, the operator, electrics, access, any pit or groundworks and out-of-hours working. Where levellers are involved, the guide assumes an existing, sound pit. After the free survey you receive a fixed written quote, and that is the price for the agreed scope.

Do vehicle restraints need servicing?

Yes. A restraint is work equipment under PUWER, so it must be maintained in a safe condition and inspected where wear could lead to danger. Servicing typically covers the rail and arm, sensors, controls and the interlock sequence with the door and lights.

What happens if a powered restraint loses power?

Powered restraints are normally designed with a manual release so a trailer is not trapped on the bay if power is lost. Your site procedure should say who is allowed to use the release and what checks they make first. We explain the release method at handover.

Vehicle restraints near Exmouth

Sites close to Exmouth get the same service, including those in Exeter (9 miles), Newton Abbot (11 miles) and Torquay (12 miles), with every job run the same way.

Other loading bay services in Exmouth

Full guide to vehicle restraints · Everything we do in Exmouth

Get in touch about loading bay doors and dock equipment in Exmouth: call, email or use the quote tool.

Call freeGet a quote