Loading bay doors and dock equipment, UK-wideFree site survey for new docks and upgradesRepair visits priced before we attend
Call free 0800 088 6248
Dock safety · Saltash

Vehicle restraints in Saltash

For operators in Saltash thinking about vehicle restraints, the starting point is a conversation about the site, the vehicles you load and how the bay is used day to day.

Guide £4,200–£9,800 per bay ex VATFree site surveyPL12
Book a free survey0800 088 6248
Location
Saltash, Cornwall
Main postcode district
PL12
Nearby (straight line)
Plymouth (4 miles), Bodmin (22 miles) and St Austell (25 miles)
Survey and quote
Free, with a fixed written quote
Vehicle restraints, in short

A vehicle restraint is a device at a loading bay that physically holds a trailer against the dock until it is safe to leave. In the UK most systems act on the rear wheel, either as a powered wheel-based restraint or a sensor wheel chock. Restraints guard against early drive-away and trailer creep, and are usually interlocked with the door and dock traffic lights.

Why do sites in Saltash choose this?

A warehouse in Saltash that already uses traffic lights may want to add restraints so the door cannot open until the trailer is physically held in place. Yards around Saltash that park uncoupled trailers at the dock can see trailers creep under forklift traffic, and a wheel-based restraint helps keep the leveller lip on the bed.

Third-party hauliers visiting sites in Saltash may not know each site's procedures, so a restraint that holds the wheel removes reliance on every driver following instructions.

We do not give a fixed price without seeing the site. A free survey in Saltash lets us check the details that affect the job, and the written quote that follows is a fixed price for the agreed scope. We plan the work around your operation, arrange out-of-hours access if you need it and manage specialist installation engineers throughout. Handover includes testing, a demonstration and the paperwork you need for your records.

How does a vehicle restraint work with dock lights and interlocks?

A vehicle restraint is normally linked to the dock traffic lights and the door controls, so engaging the restraint is what allows loading to start.

A typical sequence looks like this:

  1. The trailer reverses on to the bay with the outside light on green and the door closed.
  2. The restraint engages the rear wheel. The outside light turns red for the driver and the inside light turns green for dock staff.
  3. The door can now be opened, and the leveller can only operate once the door is fully open.
  4. When loading is finished, the leveller is parked and the door closed before the restraint can release.
  5. The restraint releases, the outside light turns green and the driver can leave.

The exact interlocks depend on your equipment and risk assessment. See dock traffic lights and interlocks for the options on signals and control logic.

Wheel-based or hook restraint: which suits UK trailers?

Wheel-based restraints and sensor wheel chocks suit most UK trailers, because they act on the rear wheel rather than on the back of the vehicle. Hook restraints, which catch the rear impact guard (sometimes called an ICC bar), are common elsewhere but suit fewer UK fleets.

  • Wheel-based restraint: a steel guide rail fixed to the yard, with an arm or chock that moves against the rear wheel, either powered or pushed into place by the operative. It works regardless of tail lifts or underrun guard design.
  • Sensor wheel chock: a heavy chock placed in front of the wheel, with a sensor or parking station that tells the dock controls it is in position. Lower cost and minimal groundwork, but it relies on someone placing it each time.
  • Hook restraint: mounted on the dock face and hooking the rear guard. UK and European trailers vary widely at the rear, and tail lifts often get in the way, so this type needs checking against your actual fleet.
Guide price, Saltash
£4,200–£9,800 per bay, ex VAT

The same published guide range applies across England; access, out-of-hours working and site conditions are confirmed at the free survey.

What do we check at the survey?

  • How often each door cycles during a typical shift
  • Whether planning, building control or a building warrant may be needed
  • Access for deliveries, cranes or lifting equipment during installation
  • Power supply at each bay, including three-phase availability
  • Wheel guide positions and yard markings for reversing vehicles
  • Age and condition of the equipment already in place

Options to discuss

Hook restraint

A dock-mounted hook that catches the trailer's rear impact guard. Only suitable where your fleet has compatible rear guards, which we check carefully at survey.

Manual wheel-based restraint

The same rail-mounted principle with the restraint pushed into position by the operative. Lower cost than a powered unit, with a sensor to confirm engagement to the controls.

What do the rules in England mean for the work?

Powered doors and dock equipment installed in England may carry the UKCA or the CE mark, and doors are covered by the product standard BS EN 13241. We hand over the relevant documentation for each item fitted in Saltash. Planning and Building Regulations questions are never assumed either way: we check what applies at survey, so you know before work is booked.

Questions about vehicle restraints in Saltash

How do you price vehicle restraints for a site in Saltash?

Guide budgets for supply and fit are £4,200 to £9,800 per bay, excluding VAT. The figure moves with size, insulation, the operator, electrics, access, any pit or groundworks and out-of-hours working. Where levellers are involved, the guide assumes an existing, sound pit. After the free survey you receive a fixed written quote, and that is the price for the agreed scope.

How long does installation take at a site in Saltash?

It depends on the equipment, the number of bays, the condition of the dock and whether any building or electrical work is needed. We agree a programme with you after the survey, setting out which bays are out of use and when. Larger jobs are usually phased so that part of the dock stays open, and out-of-hours working can be arranged.

Do you cover Saltash for vehicle restraints?

Yes. We take on vehicle restraints for businesses in Saltash and across Cornwall. We survey the site, provide a fixed written quote and manage the installation, with specialist installation engineers working under our management. Visits are arranged in advance at a time that suits your operation, and the same single contact stays with the job through to handover.

What happens if a powered restraint loses power?

Powered restraints are normally designed with a manual release so a trailer is not trapped on the bay if power is lost. Your site procedure should say who is allowed to use the release and what checks they make first. We explain the release method at handover.

Can a vehicle restraint be fitted to an existing bay?

Yes, restraints are commonly retrofitted to existing bays. The main questions are whether the yard concrete in front of the bay is sound enough to anchor a rail, how cables will reach the dock controls, and whether the existing door and leveller panels can accept interlocks. Sensor chocks are often chosen where groundwork needs to be kept to a minimum.

Vehicle restraints near Saltash

If your site is not in Saltash itself, it may be near one of these: Plymouth (4 miles), Bodmin (22 miles) and St Austell (25 miles). Pick the closest.

Other loading bay services in Saltash

Full guide to vehicle restraints · Everything we do in Saltash

Ready to talk about a loading bay in Saltash? Call us, or send the details through the quote form.

Call freeGet a quote