- Location
- Stourport-on-Severn, Worcestershire
- Main postcode district
- DY13
- Nearby (straight line)
- Kidderminster (4 miles), Droitwich (7 miles) and Bromsgrove (9 miles)
- Survey and quote
- Free, with a fixed written quote
A telescopic-lip dock leveller is a hydraulic pit leveller whose front lip slides forward out of the platform, rather than swinging on a hinge, and can be extended by a controlled amount onto the trailer bed. Telescopic lips commonly extend 500 to 1,000 mm, which lets operators reach over tail lifts, place the lip between pallets and load the last row in a trailer.
What matters for telescopic-lip dock levellers in Stourport-on-Severn?
Retail distribution sites in Stourport-on-Severn receiving both artics and tail-lift rigids at the same bays can handle the whole mix with a telescopic-lip leveller. A container-handling operation in Stourport-on-Severn can benefit from a telescopic lip, as container floors and chassis heights vary more than standard trailers.
Before recommending a lip extension for a dock in Stourport-on-Severn, we record the trailers that actually arrive, including tail lifts and rear overhangs.
Keeping the dock running is usually the first concern, so we plan around it. After a free survey of your Stourport-on-Severn site and a written quote at a fixed price, we agree when each bay can be released and whether any work should happen out of hours. Specialist installation engineers working under our management then fit the equipment, and we test it and hand over the documentation before the bay goes back into use.
How are drive-away risks managed while the lip rests on a trailer?
Drive-away risks are managed by stopping the vehicle leaving until loading has finished and the lip has been withdrawn, using traffic lights, vehicle or trailer restraints, or the person in charge keeping the keys or paperwork. HSE workplace transport guidance (HSG136) and the HSE loading factsheet (followed by HSENI in Northern Ireland) call for safeguards against drivers driving away too early.
- Why it matters: a lip resting on the bed is only safe while the trailer stays put, and trailer creep during forklift loading can open a gap at the dock edge.
- Equipment duties: the leveller is work equipment under PUWER 1998 in Great Britain or PUWER (Northern Ireland) 1999, so it must be maintained and inspected where deterioration could lead to danger. Engineering insurers commonly inspect at 12-month intervals.
- Standard: BS EN 1398:2009 sets the safety requirements for dock levellers and is current, under review.
Enforcement is by HSE in Great Britain and HSENI in Northern Ireland. Our guide to preventing drive-away and trailer creep compares the safeguards.
Why does a telescopic-lip leveller cost more than a swing-lip unit?
A telescopic-lip dock leveller typically costs £6,800 to £11,800 per leveller, excluding VAT, supply and fit, assuming an existing, sound pit. It costs more than a swing-lip unit because the lip slides in its own guides inside the platform, which means more steel, a longer lip and more involved hydraulics and controls.
Within the range, the price depends on:
- Lip extension: a longer reach needs a longer lip and stronger guides.
- Platform length and width: longer platforms give gentler gradients across mixed trailer heights.
- Capacity: higher ratings for heavy loads or large forklifts.
- Insulation: insulated platforms and pit seals for chilled and frozen docks.
- Controls: automatic return, interlocks and links to restraints and traffic lights.
New pits, pit repairs and groundworks are priced separately after survey, and the written quote is the fixed price. We often quote both lip types side by side, so you can see whether the extra flexibility justifies the cost on each bay.
The same published guide range applies across England; access, out-of-hours working and site conditions are confirmed at the free survey.
What do we check at the survey?
- Clear opening width and height for each door
- How often each door cycles during a typical shift
- Asbestos register and any other site hazard information
- Whether planning, building control or a building warrant may be needed
- Headroom above the opening and which track type will suit it
- Escape routes and pedestrian doors close to the bay
Options to discuss
Insulated cold store version
An insulated platform with perimeter seals for chilled and frozen docks, often paired with an inflatable shelter and an insulated dock door.
500 mm lip extension
A commonly specified reach for precise placement and end loading on standard trailers and refrigerated vehicles that do not have tail lifts.
Planning, building control and safety law in England
Sites in Stourport-on-Severn fall under the rules for England. Structural changes such as forming a new opening or a dock leveller pit may need Building Regulations approval, and external structures such as loading houses, canopies or new dock approaches can need planning permission from the local planning authority. We check what applies at survey and build any approvals into the plan.
Questions about telescopic-lip dock levellers in Stourport-on-Severn
Do you remove and dispose of the old equipment?
Yes, where it is part of the scope. When we replace doors, levellers, shelters or seals at a site in Stourport-on-Severn, removal and disposal of the old equipment can be included and is itemised in the quote, so it is clear what is covered. If anything should be kept, such as a frame or motor that is still serviceable, we agree that at survey.
How long does installation take at a site in Stourport-on-Severn?
It depends on the equipment, the number of bays, the condition of the dock and whether any building or electrical work is needed. We agree a programme with you after the survey, setting out which bays are out of use and when. Larger jobs are usually phased so that part of the dock stays open, and out-of-hours working can be arranged.
What details do you need from us to quote for telescopic-lip dock levellers?
To get started, send the site address in Stourport-on-Severn, the number of bays or openings, approximate sizes, and photos of the dock from inside and outside. Tell us what vehicles you load, what goods you handle and any temperature requirements. Drawings help on new builds. We then arrange the free survey and confirm the details before the written quote is issued.
Is a telescopic lip slower to operate?
Slightly, because the lip is extended as a separate movement rather than swinging out as the platform rises. In practice the difference is small, and automatic sequences can raise the platform and extend the lip in one action, then return both at the end of loading.
Do telescopic levellers need more maintenance?
They have more moving parts than a swing-lip leveller, including the lip guides and lip cylinder, so these need checking and lubricating at each service. With planned servicing the extra work is modest. Servicing is chargeable, with the visit price agreed in advance.
Telescopic-lip dock levellers near Stourport-on-Severn
If your site is not in Stourport-on-Severn itself, it may be near one of these: Kidderminster (4 miles), Droitwich (7 miles) and Bromsgrove (9 miles). Pick the closest.
Other loading bay services in Stourport-on-Severn
Full guide to telescopic-lip dock levellers · Everything we do in Stourport-on-Severn
Tell us what is happening at your Stourport-on-Severn dock, what equipment is there and when it is used, and we will suggest the right next step.