A telescopic-lip dock leveller is a hydraulic pit leveller whose front lip slides forward out of the platform, rather than swinging on a hinge, and can be extended by a controlled amount onto the trailer bed. Telescopic lips commonly extend 500 to 1,000 mm, which lets operators reach over tail lifts, place the lip between pallets and load the last row in a trailer.
What should sites in West Yorkshire consider?
Before recommending a lip extension for a dock in West Yorkshire, we record the trailers that actually arrive, including tail lifts and rear overhangs. Manufacturing sites in West Yorkshire that end-load finished goods can place the lip precisely between pallets to reach the rear row.
Parcel and courier hubs in West Yorkshire with varied vehicle types can use the longer lip reach to serve more of their fleet from fewer bays.
Keeping the dock running is usually the first concern, so we plan around it. After a free survey of your West Yorkshire site and a written quote at a fixed price, we agree when each bay can be released and whether any work should happen out of hours. Specialist installation engineers working under our management then fit the equipment, and we test it and hand over the documentation before the bay goes back into use.
Why does a telescopic-lip leveller cost more than a swing-lip unit?
A telescopic-lip dock leveller typically costs £6,800 to £11,800 per leveller, excluding VAT, supply and fit, assuming an existing, sound pit. It costs more than a swing-lip unit because the lip slides in its own guides inside the platform, which means more steel, a longer lip and more involved hydraulics and controls.
Within the range, the price depends on:
- Lip extension: a longer reach needs a longer lip and stronger guides.
- Platform length and width: longer platforms give gentler gradients across mixed trailer heights.
- Capacity: higher ratings for heavy loads or large forklifts.
- Insulation: insulated platforms and pit seals for chilled and frozen docks.
- Controls: automatic return, interlocks and links to restraints and traffic lights.
New pits, pit repairs and groundworks are priced separately after survey, and the written quote is the fixed price. We often quote both lip types side by side, so you can see whether the extra flexibility justifies the cost on each bay.
Can a telescopic leveller replace a swing-lip unit in the same pit?
Often yes, a telescopic-lip leveller can replace a swing-lip unit in the same pit, provided the pit is square and deep enough and the edge steel is in good condition. Some telescopic units need a little more depth for the lip mechanism, so we measure carefully at survey.
A typical installation:
- The bay is closed and the old leveller isolated, lifted out and removed.
- The pit is cleaned and measured, and any edge steel repairs carried out.
- The new unit is set in, levelled and fixed to the pit steel.
- The power pack, control panel and lip controls are connected and interlocks wired.
- The platform and lip are tested through their full travel.
You will need to provide a clear bay, access for lifting equipment and a suitable power supply, typically three-phase. Installation commonly takes one to two working days per bay once the pit is ready.
Towns we cover in West Yorkshire
Choose a town below to see how we handle telescopic-lip dock levellers in that part of West Yorkshire.
- Leeds
- Bradford
- Huddersfield
- Wakefield
- Halifax
- Dewsbury
- Morley
- Keighley
- Castleford
- Pontefract
- Batley
- Yeadon
- Brighouse
- Shipley
- Cleckheaton
- Pudsey
- Ossett
- Guiseley
- Liversedge
- Horsforth
- South Elmsall
- Normanton
Budget range for supply and fit. The written quote after a free survey is the fixed price. All guide prices.
Which rules apply in England?
Workplace safety in England is regulated by HSE. For a loading bay in West Yorkshire, that means doors meeting regulation 18 of the Workplace (Health, Safety and Welfare) Regulations 1992, equipment maintained under PUWER and suitable safeguards against vehicles driving away too early. We check what applies at survey and design the bay accordingly.
Questions
Do you remove and dispose of the old equipment?
Yes, where it is part of the scope. When we replace doors, levellers, shelters or seals at a site in West Yorkshire, removal and disposal of the old equipment can be included and is itemised in the quote, so it is clear what is covered. If anything should be kept, such as a frame or motor that is still serviceable, we agree that at survey.
Can you work outside our normal operating hours in West Yorkshire?
Yes, by arrangement. Evening, night and weekend working can be planned so the installation causes as little disruption as possible to your loading schedule. Out-of-hours work can affect the price, so mention it at the survey and we will include it in the written quote. The agreed times are confirmed in the programme before the job starts.
What overlap should the lip have on the trailer bed?
The lip should rest on the trailer bed with the overlap the manufacturer specifies, so it cannot slip off as the trailer moves under load. Extending further than needed adds no benefit. We show dock staff what a correct overlap looks like at handover.
Do telescopic levellers need more maintenance?
They have more moving parts than a swing-lip leveller, including the lip guides and lip cylinder, so these need checking and lubricating at each service. With planned servicing the extra work is modest. Servicing is chargeable, with the visit price agreed in advance.
Other services in West Yorkshire
Full guide to telescopic-lip dock levellers · All loading bay services in West Yorkshire