- Location
- Dudley, West Midlands
- Main postcode district
- DY1
- Nearby (straight line)
- Brierley Hill (2 miles), Tipton (2 miles) and Halesowen (4 miles)
- Survey and quote
- Free, with a fixed written quote
A telescopic-lip dock leveller is a hydraulic pit leveller whose front lip slides forward out of the platform, rather than swinging on a hinge, and can be extended by a controlled amount onto the trailer bed. Telescopic lips commonly extend 500 to 1,000 mm, which lets operators reach over tail lifts, place the lip between pallets and load the last row in a trailer.
What should sites in Dudley consider?
Before recommending a lip extension for a dock in Dudley, we record the trailers that actually arrive, including tail lifts and rear overhangs. Where docks in Dudley have deep bumpers that hold trailers away from the edge, a telescopic lip can bridge a gap a swing lip would struggle to cover.
Cold chain operators around Dudley loading refrigerated trailers right to the doors may find a telescopic lip makes the last pallets far easier to handle.
Our part of the job in Dudley is to survey, quote and manage; the fitting itself is done by specialist installation engineers working under our management. The survey and the written quote are free. Once the fixed price is accepted, we agree dates that work around your deliveries and shifts, including out-of-hours working where needed. Every installation is tested before handover, and you receive the documentation for each item fitted.
Can a telescopic leveller replace a swing-lip unit in the same pit?
Often yes, a telescopic-lip leveller can replace a swing-lip unit in the same pit, provided the pit is square and deep enough and the edge steel is in good condition. Some telescopic units need a little more depth for the lip mechanism, so we measure carefully at survey.
A typical installation:
- The bay is closed and the old leveller isolated, lifted out and removed.
- The pit is cleaned and measured, and any edge steel repairs carried out.
- The new unit is set in, levelled and fixed to the pit steel.
- The power pack, control panel and lip controls are connected and interlocks wired.
- The platform and lip are tested through their full travel.
You will need to provide a clear bay, access for lifting equipment and a suitable power supply, typically three-phase. Installation commonly takes one to two working days per bay once the pit is ready.
Which operations benefit most from a telescopic lip?
Telescopic lips benefit operations that need precise lip placement, load trailers right to the rear doors, or receive vehicles with tail lifts. A swing lip lands wherever its fixed length takes it, while a telescopic lip can be stopped exactly where it is wanted.
- End loading: the lip can be placed in the gap between pallets so the last row can be loaded or removed.
- Tail-lift trailers and rigids: the lip reaches over the folded tail lift onto the bed.
- Cold chain: pallets are often loaded tight to the rear doors of refrigerated trailers.
- Double-deck and container trailers: beds sit at varied heights and lip placement needs care.
- Mixed fleets: one bay can handle a wider range of vehicles.
For straightforward pallet loading of standard trailers, a swing-lip dock leveller is simpler and lower in cost.
The same published guide range applies across England; access, out-of-hours working and site conditions are confirmed at the free survey.
What does the free survey cover?
- Escape routes and pedestrian doors close to the bay
- Wall and steel structure for door, shelter and bumper fixings
- Headroom above the opening and which track type will suit it
- Drainage on recessed or sloping dock approaches
- How drivers are prevented from pulling away too early
- Wind exposure at the dock, which affects door and shelter choice
Options to discuss
Automatic return control
A single button that withdraws the lip and lowers the platform to its stored position, reducing the risk of a trailer leaving with the lip still out.
500 mm lip extension
A commonly specified reach for precise placement and end loading on standard trailers and refrigerated vehicles that do not have tail lifts.
Which rules apply in England?
Powered doors and dock equipment installed in England may carry the UKCA or the CE mark, and doors are covered by the product standard BS EN 13241. We hand over the relevant documentation for each item fitted in Dudley. Planning and Building Regulations questions are never assumed either way: we check what applies at survey, so you know before work is booked.
Questions about telescopic-lip dock levellers in Dudley
What details do you need from us to quote for telescopic-lip dock levellers?
To get started, send the site address in Dudley, the number of bays or openings, approximate sizes, and photos of the dock from inside and outside. Tell us what vehicles you load, what goods you handle and any temperature requirements. Drawings help on new builds. We then arrange the free survey and confirm the details before the written quote is issued.
How do you price telescopic-lip dock levellers for a site in Dudley?
Guide budgets for supply and fit are £6,800 to £11,800 per leveller, excluding VAT. The figure moves with size, insulation, the operator, electrics, access, any pit or groundworks and out-of-hours working. Where levellers are involved, the guide assumes an existing, sound pit. After the free survey you receive a fixed written quote, and that is the price for the agreed scope.
Can you work alongside our main contractor on a new build in Dudley?
Yes. For new warehouses and fit-outs, we can supply and install the dock package as part of a wider project, working to the main contractor's programme, site rules and permits. We will need drawings, dock levels and the programme, and we coordinate pit details, power supplies and door openings with the relevant trades before installation begins.
Can telescopic and swing-lip levellers be mixed on one dock?
Yes, and many sites do. Fitting telescopic levellers on the bays that receive tail-lift vehicles or need end loading, and swing-lip units on the rest, keeps costs down while covering every vehicle type. Clear bay signage helps drivers reverse onto the right one.
Do telescopic levellers need more maintenance?
They have more moving parts than a swing-lip leveller, including the lip guides and lip cylinder, so these need checking and lubricating at each service. With planned servicing the extra work is modest. Servicing is chargeable, with the visit price agreed in advance.
Telescopic-lip dock levellers near Dudley
Sites close to Dudley get the same service, including those in Brierley Hill (2 miles), Tipton (2 miles) and Halesowen (4 miles), with every job run the same way.
Other loading bay services in Dudley
Full guide to telescopic-lip dock levellers · Everything we do in Dudley
Start your enquiry for Dudley through the quote tool. A few photos and approximate sizes help us respond with something useful.