A retractable dock shelter is a fabric shelter fixed to the building around a loading bay door, with flexible top and side curtains carried on a sprung or pantograph steel frame. When a trailer reverses in, the frame retracts and the curtains drape against the trailer's sides and roof, closing most of the gap while leaving the full width of the trailer opening clear for loading.
What should sites in Warwickshire consider?
Retail and e-commerce distribution centres in Warwickshire with high trailer turnover need tough sprung-frame shelters that recover quickly after each departure. Third-party logistics sites in Warwickshire receiving trailers from many hauliers usually need a shelter rather than a seal, because widths and heights vary.
For a dock in Warwickshire where wide pallets need the full trailer opening, a shelter keeps that width clear while still closing the gaps.
Before anything is ordered, we visit your site in Warwickshire for a free survey and then send a written quote with a fixed price. From that point we manage the installation, coordinating delivery, access and any other trades. Fitting is done by specialist installation engineers engaged and managed by us, at times that suit your operation, including out of hours where agreed. You get a tested installation, a demonstration for your team and the manufacturer documentation.
How do I size a retractable shelter for my trailers?
Size a retractable shelter to the largest trailer you receive, with a projection deep enough for opened trailer doors and the leveller lip, and curtains that still reach the smallest vehicles. The trailer mix sets almost every dimension.
- Width: wider than the trailer, so the side curtains drape along its sides rather than across the opening.
- Height: high enough for the tallest trailers, with a top curtain deep enough to reach the roof of the lowest.
- Projection: deep enough for the rear doors, folded back along the trailer sides, to sit inside the curtains.
- Curtain cut-outs: vertical slits let the side curtains wrap around hinges and rear fittings without tearing.
- Guide stripes: contrasting stripes on the curtains help drivers centre the trailer.
If your fleet is uniform, a seal may give a tighter fit. Our guide to shelters and seals sets out the trade-offs.
How can I stop dock shelter curtains being torn?
Most curtain damage comes from trailers reversing in off-centre or too far, so better guidance for drivers and correctly set bumpers prevent most tears. Worn curtains can then be replaced individually without changing the frame.
- Wheel guides: steel guides on the approach steer the trailer into the centre of the bay.
- Guide stripes and lights: high-visibility stripes on the curtains and dock lights help drivers line up.
- Bumpers: worn bumpers let trailers push too far into the shelter and strain the frame.
- Frame springs: weak springs leave the frame unable to retract and recover.
- Curtain grade: heavier fabric and reinforced edges last longer at busy docks.
Checking curtains, frame and fixings at each planned service picks up damage early, before a loose curtain starts flapping in the wind and tears completely.
Towns we cover in Warwickshire
We provide retractable dock shelters right across Warwickshire. Pick the town closest to your site from the list below.
Budget range for supply and fit. The written quote after a free survey is the fixed price. All guide prices.
Which rules apply in England?
Sites in Warwickshire fall under the rules for England. Structural changes such as forming a new opening or a dock leveller pit may need Building Regulations approval, and external structures such as loading houses, canopies or new dock approaches can need planning permission from the local planning authority. We check what applies at survey and build any approvals into the plan.
Questions
Do you remove and dispose of the old equipment?
Yes, where it is part of the scope. When we replace doors, levellers, shelters or seals at a site in Warwickshire, removal and disposal of the old equipment can be included and is itemised in the quote, so it is clear what is covered. If anything should be kept, such as a frame or motor that is still serviceable, we agree that at survey.
Do you cover Warwickshire for retractable dock shelters?
Yes. We take on retractable dock shelters for businesses in Warwickshire and across Warwickshire. We survey the site, provide a fixed written quote and manage the installation, with specialist installation engineers working under our management. Visits are arranged in advance at a time that suits your operation, and the same single contact stays with the job through to handover.
What projection should a dock shelter have?
Projection should be deep enough to clear opened trailer doors and hinges and to suit the leveller lip and bumpers. Shelters are commonly made with projections from around 500 to 1,000 mm, and we recommend a depth once we know your trailers and leveller.
How do drivers know where to stop?
Bumpers set the stopping point, and many sites add dock lights, wheel guides and guide stripes on the shelter curtains to help drivers line up and reverse squarely. Traffic lights at the bay tell drivers when it is safe to reverse in and when they may leave.
Other services in Warwickshire
Full guide to retractable dock shelters · All loading bay services in Warwickshire