A retractable dock shelter is a fabric shelter fixed to the building around a loading bay door, with flexible top and side curtains carried on a sprung or pantograph steel frame. When a trailer reverses in, the frame retracts and the curtains drape against the trailer's sides and roof, closing most of the gap while leaving the full width of the trailer opening clear for loading.
How does this suit sites in the East Riding of Yorkshire?
Retail and e-commerce distribution centres in the East Riding of Yorkshire with high trailer turnover need tough sprung-frame shelters that recover quickly after each departure. Loading staff at a draughty dock in the East Riding of Yorkshire notice the difference when the gaps around the trailer are closed, especially through the colder months.
If a shelter on an older unit in the East Riding of Yorkshire has a sound frame but torn, faded curtains, replacing just the curtains can be the economical choice.
Your loading bay stays our responsibility from the survey to the handover. In the East Riding of Yorkshire, the survey and written quote are free, and the quoted price is fixed for the agreed scope. Installation is carried out by specialist engineers working under our management, at times planned with you to protect your loading schedule. Out-of-hours work is available by arrangement. We finish by testing the equipment and handing over its documentation.
How do I size a retractable shelter for my trailers?
Size a retractable shelter to the largest trailer you receive, with a projection deep enough for opened trailer doors and the leveller lip, and curtains that still reach the smallest vehicles. The trailer mix sets almost every dimension.
- Width: wider than the trailer, so the side curtains drape along its sides rather than across the opening.
- Height: high enough for the tallest trailers, with a top curtain deep enough to reach the roof of the lowest.
- Projection: deep enough for the rear doors, folded back along the trailer sides, to sit inside the curtains.
- Curtain cut-outs: vertical slits let the side curtains wrap around hinges and rear fittings without tearing.
- Guide stripes: contrasting stripes on the curtains help drivers centre the trailer.
If your fleet is uniform, a seal may give a tighter fit. Our guide to shelters and seals sets out the trade-offs.
How can I stop dock shelter curtains being torn?
Most curtain damage comes from trailers reversing in off-centre or too far, so better guidance for drivers and correctly set bumpers prevent most tears. Worn curtains can then be replaced individually without changing the frame.
- Wheel guides: steel guides on the approach steer the trailer into the centre of the bay.
- Guide stripes and lights: high-visibility stripes on the curtains and dock lights help drivers line up.
- Bumpers: worn bumpers let trailers push too far into the shelter and strain the frame.
- Frame springs: weak springs leave the frame unable to retract and recover.
- Curtain grade: heavier fabric and reinforced edges last longer at busy docks.
Checking curtains, frame and fixings at each planned service picks up damage early, before a loose curtain starts flapping in the wind and tears completely.
Towns we cover in the East Riding of Yorkshire
We cover retractable dock shelters throughout the East Riding of Yorkshire, and the towns below each have their own page. If yours is not listed, get in touch anyway.
Budget range for supply and fit. The written quote after a free survey is the fixed price. All guide prices.
Which rules apply in England?
Sites in the East Riding of Yorkshire fall under the rules for England. Structural changes such as forming a new opening or a dock leveller pit may need Building Regulations approval, and external structures such as loading houses, canopies or new dock approaches can need planning permission from the local planning authority. We check what applies at survey and build any approvals into the plan.
Questions
Is the site survey in the East Riding of Yorkshire free?
Yes. For new installations, replacements, upgrades, conversions and complete bays, the site survey and written quote are free and come with no obligation. The survey lets us measure the openings, check the dock and structure, and understand how the bay is used, so the quote reflects your site. Repair and servicing visits are different: they are chargeable, with the price agreed before anyone attends.
What details do you need from us to quote for retractable dock shelters?
To get started, send the site address in the East Riding of Yorkshire, the number of bays or openings, approximate sizes, and photos of the dock from inside and outside. Tell us what vehicles you load, what goods you handle and any temperature requirements. Drawings help on new builds. We then arrange the free survey and confirm the details before the written quote is issued.
What projection should a dock shelter have?
Projection should be deep enough to clear opened trailer doors and hinges and to suit the leveller lip and bumpers. Shelters are commonly made with projections from around 500 to 1,000 mm, and we recommend a depth once we know your trailers and leveller.
Does a dock shelter keep a building warm?
A shelter reduces the draughts and rain entering the dock around a trailer, which helps keep the loading area warmer. It does not seal as closely as a dock seal or inflatable shelter, so for chilled and frozen docks those options are usually preferred.
Other services in the East Riding of Yorkshire
Full guide to retractable dock shelters · All loading bay services in the East Riding of Yorkshire