Dock traffic lights are red and green signals mounted outside and inside a loading bay to tell the driver and dock staff when it is safe to move or load. Interlocks are control links that stop equipment operating out of sequence, for example preventing the door opening until the trailer is restrained, or the leveller operating until the door is fully open.
What matters for dock traffic lights and interlocks in Forth Valley?
New warehouses in Forth Valley can have lights and interlocks wired in during the electrical fit-out, avoiding retrofit cabling and keeping every bay on one control standard. Loading docks in Forth Valley where drivers wait in their cabs for a hand signal can replace guesswork with a clear red and green light at every bay.
Older docks in Forth Valley with separate door and leveller controls can be brought into a proper sequence by adding interlocks that stop equipment working out of order.
Any project involving dock traffic lights and interlocks at a working site in Forth Valley takes planning. We survey free of charge, quote a fixed price in writing, and then agree a programme that keeps as much of the dock running as possible. Specialist installation engineers carry out the work under our management, out of hours if that suits you better. On completion we test each item, show your team how it operates and leave the documentation with you.
How much do dock traffic lights and interlocks cost?
Dock traffic lights and interlocks typically cost £650 to £3,400 per bay, supplied and fitted, excluding VAT. A pair of manually switched LED signals sits at the lower end, while a full interlock panel linking door, leveller, restraint and shelter sits towards the top.
What moves the price:
- Level of control: standalone lights, door-linked lights or a full interlocked sequence.
- Existing control panels: modern door and leveller panels often accept interlocks directly; older panels may need replacing with a combined bay panel.
- Sensors: door position switches, trailer presence sensors and restraint signals each add parts and wiring.
- Cable runs: distances between lights, panels and the power supply.
- Number of bays and timing: repeat bays reduce the cost per bay, while out-of-hours working adds to it.
These are guide budgets. After a free site survey we send a written quote, and that quote is the fixed price. VAT is added at the standard rate.
Which interlocks should a loading bay have?
The most useful loading bay interlocks stop the door opening until the trailer is in place or restrained, and stop the leveller operating until the door is fully open. Beyond that, the right set depends on the equipment fitted and your risk assessment.
- Door to restraint: the door cannot open until the restraint is engaged or a trailer is detected.
- Leveller to door: the leveller cannot be raised until the door is fully open, which prevents the lip hitting door panels.
- Door to leveller: the door cannot close until the leveller is back in its parked position.
- Restraint release: the restraint only releases once the door is closed and the leveller parked.
- Shelter to trailer: an inflatable shelter only inflates when a trailer is docked.
On a bay without a restraint, a trailer presence sensor can take its place in the door logic, although it confirms a trailer is there rather than holding it. Combining interlocks with vehicle restraints gives the strongest protection against drive-away.
Towns we cover in Forth Valley
Choose a town below to see how we handle dock traffic lights and interlocks in that part of Forth Valley.
Budget range for supply and fit. The written quote after a free survey is the fixed price. All guide prices.
Regulations and approvals in Scotland
HSE is the workplace safety regulator in Scotland. At a loading bay in Forth Valley, doors need to satisfy regulation 18 of the Workplace (Health, Safety and Welfare) Regulations 1992, dock equipment must be kept safe under PUWER, and drivers must be prevented from pulling away too early. We check what applies at survey.
Questions
Which building and safety rules apply to a site in Forth Valley?
It depends on which UK nation the site is in. England and Wales use Building Regulations approval, Scotland uses building warrants and Northern Ireland uses building control approval from the council. Workplace safety is regulated by HSE in Great Britain and HSENI in Northern Ireland, and energy rules differ between nations. For your site in Forth Valley, we check what applies at survey and design to it.
Is VAT included in your guide prices for dock traffic lights and interlocks?
No. Our customers are businesses, so guide prices exclude VAT, which is added at the standard rate. The same guide range applies in Forth Valley as everywhere else: for dock traffic lights and interlocks, it is £650 to £3,400 per bay, excluding VAT. It covers supply and fit for a typical installation. Your fixed written quote after the free survey shows the net price, the VAT and exactly what is included.
Can you add lights and interlocks across a whole dock in one project?
Yes. A whole-dock project is usually phased bay by bay so most doors stay in use, and every bay ends up on the same control standard. That consistency makes training easier for staff and drivers, and it simplifies servicing because every bay behaves in the same way.
Can interlocks be fitted to a manual loading bay door?
Yes. A door position switch fitted to a manual door can confirm when it is fully open or fully closed. That signal lets the traffic lights change automatically and stops the leveller being raised until the door is out of the way.
Other services in Forth Valley
Full guide to dock traffic lights and interlocks · All loading bay services in Forth Valley