Dock traffic lights are red and green signals mounted outside and inside a loading bay to tell the driver and dock staff when it is safe to move or load. Interlocks are control links that stop equipment operating out of sequence, for example preventing the door opening until the trailer is restrained, or the leveller operating until the door is fully open.
Is this right for your site in Argyll and Bute?
Loading docks in Argyll and Bute where drivers wait in their cabs for a hand signal can replace guesswork with a clear red and green light at every bay. New warehouses in Argyll and Bute can have lights and interlocks wired in during the electrical fit-out, avoiding retrofit cabling and keeping every bay on one control standard.
Sites around Argyll and Bute that run night shifts often find traffic lights easier for drivers to read than staff waving or knocking on the cab door.
Keeping the dock running is usually the first concern, so we plan around it. After a free survey of your Argyll and Bute site and a written quote at a fixed price, we agree when each bay can be released and whether any work should happen out of hours. Specialist installation engineers working under our management then fit the equipment, and we test it and hand over the documentation before the bay goes back into use.
Can traffic lights and interlocks be added to older loading bays?
Yes, traffic lights and interlocks can be added to most older loading bays, although some need new control panels before the interlocks can work.
- Manual doors: a door position switch can confirm the door is fully open or closed, which lets lights and leveller interlocks work even without a motor.
- Older powered doors and levellers: basic control boxes may not have connections for interlocks, so a combined bay panel can replace separate controls.
- Mixed equipment: doors and levellers from different suppliers can usually be brought under one interlock panel, so every bay works the same way.
Interlocks cannot make faulty equipment safe. If a door or leveller has a defect, it should be repaired before interlocks are added, and the survey will flag anything we find. Upgrading lights and interlocks at the same time as replacing a door or leveller is often the most economical moment to do it.
How much do dock traffic lights and interlocks cost?
Dock traffic lights and interlocks typically cost £650 to £3,400 per bay, supplied and fitted, excluding VAT. A pair of manually switched LED signals sits at the lower end, while a full interlock panel linking door, leveller, restraint and shelter sits towards the top.
What moves the price:
- Level of control: standalone lights, door-linked lights or a full interlocked sequence.
- Existing control panels: modern door and leveller panels often accept interlocks directly; older panels may need replacing with a combined bay panel.
- Sensors: door position switches, trailer presence sensors and restraint signals each add parts and wiring.
- Cable runs: distances between lights, panels and the power supply.
- Number of bays and timing: repeat bays reduce the cost per bay, while out-of-hours working adds to it.
These are guide budgets. After a free site survey we send a written quote, and that quote is the fixed price. VAT is added at the standard rate.
Towns we cover in Argyll and Bute
We cover dock traffic lights and interlocks throughout Argyll and Bute, and the towns below each have their own page. If yours is not listed, get in touch anyway.
Budget range for supply and fit. The written quote after a free survey is the fixed price. All guide prices.
Regulations and approvals in Scotland
Energy standards for buildings in Scotland are set out in Section 6 of the Building Standards Technical Handbook. For new or replacement loading bay doors in Argyll and Bute, we confirm the figure that applies to your project and check what applies at survey, rather than relying on rules written for elsewhere in the UK.
Questions
Can you work outside our normal operating hours in Argyll and Bute?
Yes, by arrangement. Evening, night and weekend working can be planned so the installation causes as little disruption as possible to your loading schedule. Out-of-hours work can affect the price, so mention it at the survey and we will include it in the written quote. The agreed times are confirmed in the programme before the job starts.
How long does installation take at a site in Argyll and Bute?
It depends on the equipment, the number of bays, the condition of the dock and whether any building or electrical work is needed. We agree a programme with you after the survey, setting out which bays are out of use and when. Larger jobs are usually phased so that part of the dock stays open, and out-of-hours working can be arranged.
Can you add lights and interlocks across a whole dock in one project?
Yes. A whole-dock project is usually phased bay by bay so most doors stay in use, and every bay ends up on the same control standard. That consistency makes training easier for staff and drivers, and it simplifies servicing because every bay behaves in the same way.
Can interlocks be fitted to a manual loading bay door?
Yes. A door position switch fitted to a manual door can confirm when it is fully open or fully closed. That signal lets the traffic lights change automatically and stops the leveller being raised until the door is out of the way.
Other services in Argyll and Bute
Full guide to dock traffic lights and interlocks · All loading bay services in Argyll and Bute