- Location
- Burnham-on-Sea, Somerset
- Main postcode district
- TA8
- Nearby (straight line)
- Weston-super-Mare (7 miles), Bridgwater (8 miles) and Clevedon (15 miles)
- Visit pricing
- Agreed in writing before we attend
Dock shelter and seal repair covers restoring the weather seal around a docked trailer. Typical work includes replacing torn side and head curtains, worn foam seal pads and their covers, top pads and guide strips, repairing or replacing airbags and blowers on inflatable shelters, and straightening or replacing bent shelter frames, so the bay closes the gap between building and trailer again.
Is this right for your site in Burnham-on-Sea?
Exposed yards in Burnham-on-Sea that catch strong winds can tear shelter curtains or strain frames, letting weather into the dock until parts are replaced. If tenants change at a unit in Burnham-on-Sea, checking the shelters and seals is sensible, because a new fleet may not suit the old curtain sizes.
Older retractable shelters on estates around Burnham-on-Sea can often be refurbished with new curtains and pads rather than replaced, provided the frame is still sound.
Tell us what has gone wrong at your Burnham-on-Sea site and, if you can, send photos of the fault and any labels on the equipment. We then confirm the visit price in writing, and nobody attends until you have agreed it. On site, the engineer diagnoses and repairs what was agreed; anything extra is quoted first, never added without your say-so. A written report follows, covering findings, work carried out and recommendations.
Why is my dock shelter or seal letting in draughts?
A dock shelter or seal lets in draughts when the material that should press against the trailer is torn, worn, too short or no longer in the right place. Daylight around a docked trailer is the clearest sign.
- Torn or shrunk curtains: side curtains no longer overlap the trailer sides.
- Short head curtain: taller trailers than the shelter was sized for leave a gap across the top.
- Flattened seal pads: foam that has lost its spring no longer closes the gap.
- Worn pad covers: exposed foam soaks up water and breaks down faster.
- Bent frame: a retractable shelter frame that no longer returns square.
- Airbag or blower fault: inflatable shelters that inflate slowly or lose pressure.
- Trailer position: off-centre parking or worn bumpers that let trailers crush one side.
On chilled docks, gaps also show up as condensation, ice on the dock floor or frost around the door.
What happens on site during a shelter or seal repair?
During a shelter or seal repair the bay is closed to trailers while the engineer works from the yard, often using access equipment for the head curtain and top pad. Neighbouring bays can usually keep working, although access equipment may need space in front of them.
- Measure: where parts are made to measure, the shelter or seal is measured first and the parts ordered.
- Close the bay: no trailer on the dock and the yard area coned off.
- Isolate: on inflatable shelters, the blower supply is isolated and locked off.
- Replace parts: old curtains, pads or airbags are removed and new ones fitted, with frames straightened or replaced as agreed.
- Check the seal: overlap and compression are checked, with a trailer docked if one is available.
It helps if you can provide photos with a trailer docked, yard space for access equipment, a contact who can arrange electrical isolation and an agreed time when the bay can be released.
The visit price is agreed before anyone attends. Parts and any extra work are quoted before they are fitted.
Bay checks on a repair or service visit
- Pit frame welds, platform cracks and structural damage
- Vehicle restraint engagement and its signal sequence
- Wiring, isolators and motor performance under load
- Safety edges, photocells and light curtains
- Lip hinge, lip extension and lip support operation
- Door springs, cables and drums for wear or damage
Options to discuss
Top pad and guide strip replacement
Renewing head pads, top seals and high-visibility guide strips that close the gap above the trailer and help drivers line up on the bay.
Seal pad refurbishment
Replacing worn foam pads, or just their covers where the foam is still sound, including tougher facings on the areas where trailers rub most.
Regulations and approvals in England
Powered doors and dock equipment installed in England may carry the UKCA or the CE mark, and doors are covered by the product standard BS EN 13241. We hand over the relevant documentation for each item fitted in Burnham-on-Sea. Planning and Building Regulations questions are never assumed either way: we check what applies before any work starts, so you know before work is booked.
Questions about dock shelter and seal repairs in Burnham-on-Sea
What happens if the engineer finds the equipment unsafe?
If equipment is found to be unsafe, the engineer will tell you straight away and recommend that it is isolated and taken out of use until it is repaired. That is recorded in the written report. We then quote the repair so you can decide how to proceed. Keeping an unsafe door or leveller in service puts people at risk, so we will always raise it.
Do you provide a written report after each visit?
Yes. After every repair or service visit to a site in Burnham-on-Sea, you receive a written report setting out what was checked, what was found, what work was carried out and anything that still needs attention, with a quote for further work where needed. The report is useful for your maintenance records and for discussions with your insurer or inspector.
Do you cover Somerset for dock shelter and seal repairs?
Yes. We take on dock shelter and seal repairs for sites in Burnham-on-Sea and throughout Somerset. Each visit is arranged in advance, with the price agreed in writing before anyone attends. Specialist service engineers working under our management carry out the work, and we remain your point of contact from the first call to the written report.
Can worn dock seal covers be replaced without new foam?
Often, yes. If the foam inside a seal pad still springs back, a new cover can be fitted over it. If the foam has stayed compressed or soaked up water, the pad is usually replaced complete. Photos of the pads, front and side, help us judge which applies.
Do you repair inflatable dock shelters?
Yes. We repair and replace torn airbags, failed blower motors, controls and fixings on inflatable shelters. Where the shelter is interlocked with the dock controls so it only inflates with a trailer present, that link is checked as part of the repair.
Dock shelter and seal repairs near Burnham-on-Sea
Close neighbours of Burnham-on-Sea with their own pages here: Weston-super-Mare (7 miles), Bridgwater (8 miles) and Clevedon (15 miles). Choose one to see coverage details for that town.
Other loading bay services in Burnham-on-Sea
Full guide to dock shelter and seal repairs · Everything we do in Burnham-on-Sea
Have photos of the door, leveller or shelter? Send them with your enquiry and we can give a clearer answer for your Burnham-on-Sea site.