- Location
- Epsom, Surrey
- Main postcode districts
- KT17 and KT19
- Nearby (straight line)
- Sutton (3 miles), Worcester Park (4 miles) and Leatherhead (4 miles)
- Survey and quote
- Free, with a fixed written quote
A telescopic-lip dock leveller is a hydraulic pit leveller whose front lip slides forward out of the platform, rather than swinging on a hinge, and can be extended by a controlled amount onto the trailer bed. Telescopic lips commonly extend 500 to 1,000 mm, which lets operators reach over tail lifts, place the lip between pallets and load the last row in a trailer.
Where does this fit at a dock in Epsom?
Where docks in Epsom have deep bumpers that hold trailers away from the edge, a telescopic lip can bridge a gap a swing lip would struggle to cover. Parcel and courier hubs in Epsom with varied vehicle types can use the longer lip reach to serve more of their fleet from fewer bays.
Retail distribution sites in Epsom receiving both artics and tail-lift rigids at the same bays can handle the whole mix with a telescopic-lip leveller.
We never ask you to commit before you have a fixed price. A free survey at your Epsom site comes first, followed by a written quote. When the order goes ahead, we plan the installation around your operation, book any out-of-hours working you need and manage the specialist installation engineers on site. The job ends with a full test, a run-through for the people who will use the equipment and a set of handover documents.
Which operations benefit most from a telescopic lip?
Telescopic lips benefit operations that need precise lip placement, load trailers right to the rear doors, or receive vehicles with tail lifts. A swing lip lands wherever its fixed length takes it, while a telescopic lip can be stopped exactly where it is wanted.
- End loading: the lip can be placed in the gap between pallets so the last row can be loaded or removed.
- Tail-lift trailers and rigids: the lip reaches over the folded tail lift onto the bed.
- Cold chain: pallets are often loaded tight to the rear doors of refrigerated trailers.
- Double-deck and container trailers: beds sit at varied heights and lip placement needs care.
- Mixed fleets: one bay can handle a wider range of vehicles.
For straightforward pallet loading of standard trailers, a swing-lip dock leveller is simpler and lower in cost.
Can a telescopic leveller replace a swing-lip unit in the same pit?
Often yes, a telescopic-lip leveller can replace a swing-lip unit in the same pit, provided the pit is square and deep enough and the edge steel is in good condition. Some telescopic units need a little more depth for the lip mechanism, so we measure carefully at survey.
A typical installation:
- The bay is closed and the old leveller isolated, lifted out and removed.
- The pit is cleaned and measured, and any edge steel repairs carried out.
- The new unit is set in, levelled and fixed to the pit steel.
- The power pack, control panel and lip controls are connected and interlocks wired.
- The platform and lip are tested through their full travel.
You will need to provide a clear bay, access for lifting equipment and a suitable power supply, typically three-phase. Installation commonly takes one to two working days per bay once the pit is ready.
The same published guide range applies across England; access, out-of-hours working and site conditions are confirmed at the free survey.
What does the free survey cover?
- Temperature requirements for chilled, frozen or ambient goods
- Headroom above the opening and which track type will suit it
- How often each door cycles during a typical shift
- Asbestos register and any other site hazard information
- Condition of any existing leveller pit, kerb angles and pit drainage
- Wall and steel structure for door, shelter and bumper fixings
Options to discuss
Insulated cold store version
An insulated platform with perimeter seals for chilled and frozen docks, often paired with an inflatable shelter and an insulated dock door.
500 mm lip extension
A commonly specified reach for precise placement and end loading on standard trailers and refrigerated vehicles that do not have tail lifts.
Planning, building control and safety law in England
Lift tables and dock lifts in Epsom may fall under LOLER, with thorough examination at least every 12 months, or every 6 months where people are lifted. It depends on the equipment and how it is used, and your insurer or competent person will confirm. Dock levellers are usually treated as work equipment under PUWER. We check what applies at survey.
Questions about telescopic-lip dock levellers in Epsom
How long does installation take at a site in Epsom?
It depends on the equipment, the number of bays, the condition of the dock and whether any building or electrical work is needed. We agree a programme with you after the survey, setting out which bays are out of use and when. Larger jobs are usually phased so that part of the dock stays open, and out-of-hours working can be arranged.
How do you price telescopic-lip dock levellers for a site in Epsom?
Guide budgets for supply and fit are £6,800 to £11,800 per leveller, excluding VAT. The figure moves with size, insulation, the operator, electrics, access, any pit or groundworks and out-of-hours working. Where levellers are involved, the guide assumes an existing, sound pit. After the free survey you receive a fixed written quote, and that is the price for the agreed scope.
Can you work alongside our main contractor on a new build in Epsom?
Yes. For new warehouses and fit-outs, we can supply and install the dock package as part of a wider project, working to the main contractor's programme, site rules and permits. We will need drawings, dock levels and the programme, and we coordinate pit details, power supplies and door openings with the relevant trades before installation begins.
Do telescopic levellers need more maintenance?
They have more moving parts than a swing-lip leveller, including the lip guides and lip cylinder, so these need checking and lubricating at each service. With planned servicing the extra work is modest. Servicing is chargeable, with the visit price agreed in advance.
Can telescopic and swing-lip levellers be mixed on one dock?
Yes, and many sites do. Fitting telescopic levellers on the bays that receive tail-lift vehicles or need end loading, and swing-lip units on the rest, keeps costs down while covering every vehicle type. Clear bay signage helps drivers reverse onto the right one.
Telescopic-lip dock levellers near Epsom
Nearby places we cover, measured from Epsom, include Sutton (3 miles), Worcester Park (4 miles) and Leatherhead (4 miles). Ask if your own town is missing.
Other loading bay services in Epsom
Full guide to telescopic-lip dock levellers · Everything we do in Epsom
Send a few photos of the dock and a short description of the problem, and we will come back to you about your Epsom site.