- Location
- Arbroath, Dundee and Angus
- Main postcode district
- DD11
- Nearby (straight line)
- Montrose (11 miles), Forfar (13 miles) and Dundee (16 miles)
- Survey and quote
- Free, with a fixed written quote
A telescopic-lip dock leveller is a hydraulic pit leveller whose front lip slides forward out of the platform, rather than swinging on a hinge, and can be extended by a controlled amount onto the trailer bed. Telescopic lips commonly extend 500 to 1,000 mm, which lets operators reach over tail lifts, place the lip between pallets and load the last row in a trailer.
Why do sites in Arbroath choose this?
Cold chain operators around Arbroath loading refrigerated trailers right to the doors may find a telescopic lip makes the last pallets far easier to handle. Where docks in Arbroath have deep bumpers that hold trailers away from the edge, a telescopic lip can bridge a gap a swing lip would struggle to cover.
Before recommending a lip extension for a dock in Arbroath, we record the trailers that actually arrive, including tail lifts and rear overhangs.
Your loading bay stays our responsibility from the survey to the handover. In Arbroath, the survey and written quote are free, and the quoted price is fixed for the agreed scope. Installation is carried out by specialist engineers working under our management, at times planned with you to protect your loading schedule. Out-of-hours work is available by arrangement. We finish by testing the equipment and handing over its documentation.
Can a telescopic leveller replace a swing-lip unit in the same pit?
Often yes, a telescopic-lip leveller can replace a swing-lip unit in the same pit, provided the pit is square and deep enough and the edge steel is in good condition. Some telescopic units need a little more depth for the lip mechanism, so we measure carefully at survey.
A typical installation:
- The bay is closed and the old leveller isolated, lifted out and removed.
- The pit is cleaned and measured, and any edge steel repairs carried out.
- The new unit is set in, levelled and fixed to the pit steel.
- The power pack, control panel and lip controls are connected and interlocks wired.
- The platform and lip are tested through their full travel.
You will need to provide a clear bay, access for lifting equipment and a suitable power supply, typically three-phase. Installation commonly takes one to two working days per bay once the pit is ready.
Why does a telescopic-lip leveller cost more than a swing-lip unit?
A telescopic-lip dock leveller typically costs £6,800 to £11,800 per leveller, excluding VAT, supply and fit, assuming an existing, sound pit. It costs more than a swing-lip unit because the lip slides in its own guides inside the platform, which means more steel, a longer lip and more involved hydraulics and controls.
Within the range, the price depends on:
- Lip extension: a longer reach needs a longer lip and stronger guides.
- Platform length and width: longer platforms give gentler gradients across mixed trailer heights.
- Capacity: higher ratings for heavy loads or large forklifts.
- Insulation: insulated platforms and pit seals for chilled and frozen docks.
- Controls: automatic return, interlocks and links to restraints and traffic lights.
New pits, pit repairs and groundworks are priced separately after survey, and the written quote is the fixed price. We often quote both lip types side by side, so you can see whether the extra flexibility justifies the cost on each bay.
The same published guide range applies across Scotland; access, out-of-hours working and site conditions are confirmed at the free survey.
What does the free survey cover?
- Wall and steel structure for door, shelter and bumper fixings
- Whether planning, building control or a building warrant may be needed
- How often each door cycles during a typical shift
- Gaps around trailers where heated or chilled air escapes
- Drainage on recessed or sloping dock approaches
- Yard gradient and the slope of the approach to the dock
Options to discuss
500 mm lip extension
A commonly specified reach for precise placement and end loading on standard trailers and refrigerated vehicles that do not have tail lifts.
Insulated cold store version
An insulated platform with perimeter seals for chilled and frozen docks, often paired with an inflatable shelter and an insulated dock door.
Regulations and approvals in Scotland
Doors and dock equipment installed in Scotland may carry the UKCA or the CE mark, and we pass on the documentation for everything fitted in Arbroath. Because building warrant and planning questions can affect the programme, we check what applies at survey and raise any approvals early rather than assuming none are needed.
Questions about telescopic-lip dock levellers in Arbroath
Which building and safety rules apply to a site in Arbroath?
It depends on which UK nation the site is in. England and Wales use Building Regulations approval, Scotland uses building warrants and Northern Ireland uses building control approval from the council. Workplace safety is regulated by HSE in Great Britain and HSENI in Northern Ireland, and energy rules differ between nations. For your site in Arbroath, we check what applies at survey and design to it.
Will you deal with building control and planning for a project in Arbroath?
We check at survey whether the work is likely to need approval. Forming a new opening or dock pit may need Building Regulations approval, a building warrant or building control approval, depending on the nation, and external structures such as loading houses can need planning permission. Where approval is needed, we explain what is involved, work with your designer or agent, and build it into the programme.
Do you remove and dispose of the old equipment?
Yes, where it is part of the scope. When we replace doors, levellers, shelters or seals at a site in Arbroath, removal and disposal of the old equipment can be included and is itemised in the quote, so it is clear what is covered. If anything should be kept, such as a frame or motor that is still serviceable, we agree that at survey.
What overlap should the lip have on the trailer bed?
The lip should rest on the trailer bed with the overlap the manufacturer specifies, so it cannot slip off as the trailer moves under load. Extending further than needed adds no benefit. We show dock staff what a correct overlap looks like at handover.
Is a telescopic lip slower to operate?
Slightly, because the lip is extended as a separate movement rather than swinging out as the platform rises. In practice the difference is small, and automatic sequences can raise the platform and extend the lip in one action, then return both at the end of loading.
Telescopic-lip dock levellers near Arbroath
Nearby places we cover, measured from Arbroath, include Montrose (11 miles), Forfar (13 miles) and Dundee (16 miles). Ask if your own town is missing.
Other loading bay services in Arbroath
Full guide to telescopic-lip dock levellers · Everything we do in Arbroath
If a loading bay in Arbroath needs attention, call us or send photos and details online.