- Location
- Ellesmere Port, Cheshire
- Main postcode districts
- CH65 and CH66
- Nearby (straight line)
- Garston (4 miles), Speke (5 miles) and Hunts Cross (6 miles)
- Survey and quote
- Free, with a fixed written quote
A retractable dock shelter is a fabric shelter fixed to the building around a loading bay door, with flexible top and side curtains carried on a sprung or pantograph steel frame. When a trailer reverses in, the frame retracts and the curtains drape against the trailer's sides and roof, closing most of the gap while leaving the full width of the trailer opening clear for loading.
How does this suit sites in Ellesmere Port?
Docks facing open ground in Ellesmere Port can catch rain driven sideways into the bay, which a well-fitted retractable shelter helps keep out. Industrial landlords in Ellesmere Port refreshing a multi-let estate can fit shelters that suit a range of future tenants and the trailers they may use.
Shelter sizing for a bay in Ellesmere Port starts with measuring the door and wall and recording the tallest, lowest and widest trailers you receive.
We keep the process simple for sites in Ellesmere Port. A free survey tells us what the dock needs; a fixed written quote tells you what it will cost and what is included. We then organise the installation, with specialist engineers under our management and a programme agreed around your shifts. Night and weekend work is available by arrangement. Before we leave, the new equipment is tested, demonstrated and handed over with its documentation.
How do I size a retractable shelter for my trailers?
Size a retractable shelter to the largest trailer you receive, with a projection deep enough for opened trailer doors and the leveller lip, and curtains that still reach the smallest vehicles. The trailer mix sets almost every dimension.
- Width: wider than the trailer, so the side curtains drape along its sides rather than across the opening.
- Height: high enough for the tallest trailers, with a top curtain deep enough to reach the roof of the lowest.
- Projection: deep enough for the rear doors, folded back along the trailer sides, to sit inside the curtains.
- Curtain cut-outs: vertical slits let the side curtains wrap around hinges and rear fittings without tearing.
- Guide stripes: contrasting stripes on the curtains help drivers centre the trailer.
If your fleet is uniform, a seal may give a tighter fit. Our guide to shelters and seals sets out the trade-offs.
How much does a retractable dock shelter cost?
A retractable dock shelter typically costs £1,900 to £4,400 per shelter, excluding VAT, supply and fit. Most of the variation comes from size, projection and the curtain specification.
- Size: width and height, set by your door and the largest trailers you receive.
- Projection: deeper shelters cost more but leave room for opened trailer doors and the leveller lip.
- Curtains: heavier-grade fabrics, slit side curtains, adjustable top curtains and guide stripes.
- Frame: sprung, pantograph or rigid, in a galvanised or painted finish.
- Fixings: fixing to cladding usually needs a steel subframe or spreader plates.
- Access and removal: powered access equipment in the yard, and taking down an old shelter.
On an older shelter with a sound frame, new curtains may be all that is needed, and we will say so if that is the case. Every price is fixed in the written quote after a free site survey.
The same published guide range applies across England; access, out-of-hours working and site conditions are confirmed at the free survey.
What we look at on site
- Bumper position and wear or damage on the dock face
- Escape routes and pedestrian doors close to the bay
- Condition of any existing leveller pit, kerb angles and pit drainage
- Scope to convert ground-level doors into docks or add lift tables
- Control positions, isolators and any existing interlocks
- Clear opening width and height for each door
Options to discuss
Sprung-frame shelter
Side frames on springs that fold back when a trailer pushes in and recover when it leaves, a robust choice for busy docks and mixed fleets.
Adjustable top curtain
A top curtain that can be lowered or raised to suit the height of the trailers you receive, closing the gap above lower vehicles.
Which rules apply in England?
Workplace safety in England is regulated by HSE. For a loading bay in Ellesmere Port, that means doors meeting regulation 18 of the Workplace (Health, Safety and Welfare) Regulations 1992, equipment maintained under PUWER and suitable safeguards against vehicles driving away too early. We check what applies at survey and design the bay accordingly.
Questions about retractable dock shelters in Ellesmere Port
Do you remove and dispose of the old equipment?
Yes, where it is part of the scope. When we replace doors, levellers, shelters or seals at a site in Ellesmere Port, removal and disposal of the old equipment can be included and is itemised in the quote, so it is clear what is covered. If anything should be kept, such as a frame or motor that is still serviceable, we agree that at survey.
Will you deal with building control and planning for a project in Ellesmere Port?
We check at survey whether the work is likely to need approval. Forming a new opening or dock pit may need Building Regulations approval, a building warrant or building control approval, depending on the nation, and external structures such as loading houses can need planning permission. Where approval is needed, we explain what is involved, work with your designer or agent, and build it into the programme.
Can you work alongside our main contractor on a new build in Ellesmere Port?
Yes. For new warehouses and fit-outs, we can supply and install the dock package as part of a wider project, working to the main contractor's programme, site rules and permits. We will need drawings, dock levels and the programme, and we coordinate pit details, power supplies and door openings with the relevant trades before installation begins.
Can a shelter be fixed to a cladded wall?
Yes, but cladding on its own is not usually strong enough to carry a shelter. We fix through to the building's steel frame behind the cladding, or use a steel subframe or spreader plates to spread the load, and confirm the method after inspecting the wall.
What projection should a dock shelter have?
Projection should be deep enough to clear opened trailer doors and hinges and to suit the leveller lip and bumpers. Shelters are commonly made with projections from around 500 to 1,000 mm, and we recommend a depth once we know your trailers and leveller.
Retractable dock shelters near Ellesmere Port
If your site is not in Ellesmere Port itself, it may be near one of these: Garston (4 miles), Speke (5 miles) and Hunts Cross (6 miles). Pick the closest.
Other loading bay services in Ellesmere Port
Full guide to retractable dock shelters · Everything we do in Ellesmere Port
Ready to talk about a loading bay in Ellesmere Port? Call us, or send the details through the quote form.