- Location
- Bridgwater, Somerset
- Main postcode district
- TA6
- Nearby (straight line)
- Burnham-on-Sea (8 miles), Taunton (9 miles) and Weston-super-Mare (15 miles)
- Survey and quote
- Free, with a fixed written quote
An inflatable dock shelter is a dock shelter with air-filled fabric cushions at the top and sides of the opening, kept deflated and close to the building until a trailer has reversed in. A fan then inflates the cushions so they press against the trailer roof and sides, giving a close seal that adapts to different trailer widths and heights, and deflates again before the trailer leaves.
Is this right for your site in Bridgwater?
Operators replacing foam seals in Bridgwater that keep wearing out against ill-fitting trailers may find an inflatable shelter suffers far less rubbing. Driving rain and wind at an open bay in Bridgwater can wear cushion fabric, so a protective outer cover is worth considering on exposed docks.
When a chilled dock in Bridgwater sees condensation and ice around the door, the seal at the trailer is often where improvement starts.
Here is what happens after you contact us about a site in Bridgwater. We arrange a free survey, measure up and send a fixed written quote. If you go ahead, we manage the whole job, including ordering, delivery and coordination with your site team. Specialist installation engineers working under our management do the fitting, at times built around your loading schedule, with out-of-hours work by arrangement. Testing and handover documents close the job.
Inflatable shelter, curtain shelter or dock seal: which suits a cold chain dock?
For a cold chain dock that receives trailers of different sizes, an inflatable shelter usually gives the best balance of close sealing and flexibility. A dock seal can match it on a uniform fleet, while a curtain shelter is better suited to ambient bays.
- Inflatable shelter: cushions adapt to each trailer's width and height and seal close to the body, with the full opening left clear.
- Dock seal: a tight, lower-cost seal when every trailer is the same size, but it can leave gaps on other vehicles and the pads can intrude into the opening.
- Curtain shelter: flexible and robust, but leaves small gaps that matter more at chilled and frozen docks.
Inflatables also stand clear of the trailer until it has docked, avoiding the rubbing that wears foam pads and curtains. The trade-off is the fan and controls, which need power and servicing. For frozen docks we specify the shelter alongside cold store dock doors so the two work together.
What is involved in installing an inflatable dock shelter?
Installing an inflatable shelter involves fixing a steel frame to the building around the dock door, mounting the cushions and fan, and wiring the controls, usually over one to two days per bay.
- The wall is checked and fixing points or a subframe prepared.
- The frame is fixed from powered access equipment in the yard.
- Top and side cushions are fitted, with protective covers where specified.
- The fan unit is mounted and the control panel wired, including interlocks to the door, leveller or restraint.
- Inflation, deflation and cushion retraction are tested with a trailer in the bay.
You will need to provide a clear yard area in front of the bay, take the bay out of use and arrange a power supply near the door, or ask us to include one. At cold stores we plan the work with the dock door kept closed, so the store stays at temperature while the shelter goes up outside.
The same published guide range applies across England; access, out-of-hours working and site conditions are confirmed at the free survey.
What does the free survey cover?
- Scope to convert ground-level doors into docks or add lift tables
- Gaps around trailers where heated or chilled air escapes
- Control positions, isolators and any existing interlocks
- Headroom above the opening and which track type will suit it
- How drivers are prevented from pulling away too early
- Drainage on recessed or sloping dock approaches
Options to discuss
Top cushion only
A single inflatable cushion across the top of the opening, paired with fixed side pads or curtains, for docks where trailer heights vary more than widths.
Protective outer covers
Hard-wearing covers over the cushions that shield the fabric from weather, sunlight and trailer contact, extending cushion life on exposed docks.
Which rules apply in England?
Powered doors and dock equipment installed in England may carry the UKCA or the CE mark, and doors are covered by the product standard BS EN 13241. We hand over the relevant documentation for each item fitted in Bridgwater. Planning and Building Regulations questions are never assumed either way: we check what applies at survey, so you know before work is booked.
Questions about inflatable dock shelters in Bridgwater
How long does installation take at a site in Bridgwater?
It depends on the equipment, the number of bays, the condition of the dock and whether any building or electrical work is needed. We agree a programme with you after the survey, setting out which bays are out of use and when. Larger jobs are usually phased so that part of the dock stays open, and out-of-hours working can be arranged.
Which building and safety rules apply to a site in Bridgwater?
It depends on which UK nation the site is in. England and Wales use Building Regulations approval, Scotland uses building warrants and Northern Ireland uses building control approval from the council. Workplace safety is regulated by HSE in Great Britain and HSENI in Northern Ireland, and energy rules differ between nations. For your site in Bridgwater, we check what applies at survey and design to it.
Can you work outside our normal operating hours in Bridgwater?
Yes, by arrangement. Evening, night and weekend working can be planned so the installation causes as little disruption as possible to your loading schedule. Out-of-hours work can affect the price, so mention it at the survey and we will include it in the written quote. The agreed times are confirmed in the programme before the job starts.
Will we need to change the rest of the dock?
Usually not. Most inflatable shelters fit around an existing door opening, though the leveller, bumpers and door controls are reviewed so the cushions clear them and the interlocks work. Where the wall cannot carry the frame, a subframe is added. We confirm what is needed at survey.
Can a punctured cushion be repaired?
Small punctures and tears can usually be patched, and a badly damaged cushion can be replaced on its own without changing the frame or fan. Repairs are carried out on a chargeable visit, with the price agreed before anyone attends.
Inflatable dock shelters near Bridgwater
If your site is not in Bridgwater itself, it may be near one of these: Burnham-on-Sea (8 miles), Taunton (9 miles) and Weston-super-Mare (15 miles). Pick the closest.
Other loading bay services in Bridgwater
Full guide to inflatable dock shelters · Everything we do in Bridgwater
Speak to us about your Bridgwater loading bay. We will ask the right questions, then set out the next step clearly.