Edge-of-dock levellers in Kilwinning

Location

Kilwinning, Ayrshire

Main postcode district

KA13

Nearby (straight line)

Irvine (3 miles), Kilmarnock (9 miles) and Ayr (13 miles)

Survey and quote

Free, with a fixed written quote

Why do sites in Kilwinning choose this?

Tenants of leased warehouses in Kilwinning who cannot cut into the slab may find an edge-of-dock leveller the most workable way to improve loading. Smaller distribution units in Kilwinning without dock pits can add a practical loading position with an edge-of-dock leveller fixed straight to the dock face.

If trailer heights at a site in Kilwinning vary widely, our survey will tell you plainly whether an edge-of-dock leveller can cope or a pit leveller is needed.

Here is what happens after you contact us about a site in Kilwinning. We arrange a free survey, measure up and send a fixed written quote. If you go ahead, we manage the whole job, including ordering, delivery and coordination with your site team. Specialist installation engineers working under our management do the fitting, at times built around your loading schedule, with out-of-hours work by arrangement. Testing and handover documents close the job.

How is an edge-of-dock leveller fitted to an existing dock?

An edge-of-dock leveller is fixed to the front face or top edge of the dock from the yard side, and installation usually takes around half a day to a day per bay. No digging is involved.

1. The dock face is inspected, and damaged concrete or worn edge steel is repaired or replaced first if needed.
2. The leveller is positioned centrally on the door opening and bolted or welded in place.
3. Bumpers are fitted or repositioned so trailers stop at the right distance from the plate.
4. On hydraulic units, the power pack and controls are connected.
5. The leveller is tested across its working range.

You will need to keep the yard approach to the bay clear, take the bay out of use and, for hydraulic units, provide a power supply near the door or ask us to include one. Because the work is outside, very wet or freezing weather can affect welding and fixing, so we keep the date flexible where we can.

Should I choose a mechanical or hydraulic edge-of-dock leveller?

Choose a mechanical edge-of-dock leveller for occasional use and simple sites, and a hydraulic one where the bay is busy or operators need push-button control. Both bridge a similar small height range.

• Mechanical: the operator pulls a lever or handle and the lip lifts and drops onto the bed with spring assistance. No power is needed and there is little to go wrong, but it takes some physical effort.
• Hydraulic: a push button raises the plate and extends the lip, then lowers it onto the trailer. It is easier and quicker for frequent use and can be interlocked with the dock door and traffic lights.

Other choices include plate width, which should suit the wheel track of your pallet trucks and forklifts, and capacity, which must cover the truck and its heaviest load. On exposed external docks, a galvanised or well-painted finish helps the unit cope with rain, frost and road salt.

Survey checklist for your dock

• Control positions, isolators and any existing interlocks
• Condition of any existing leveller pit, kerb angles and pit drainage
• Bumper position and wear or damage on the dock face
• Whether planning, building control or a building warrant may be needed
• Scope to convert ground-level doors into docks or add lift tables
• Dock height and the mix of trailers you load

Options to discuss

What do the rules in Scotland mean for the work?

Doors and dock equipment installed in Scotland may carry the UKCA or the CE mark, and we pass on the documentation for everything fitted in Kilwinning. Because building warrant and planning questions can affect the programme, we check what applies at survey and raise any approvals early rather than assuming none are needed.

Questions about edge-of-dock levellers in Kilwinning

Edge-of-dock levellers near Kilwinning

Close neighbours of Kilwinning with their own pages here: Irvine (3 miles), Kilmarnock (9 miles) and Ayr (13 miles). Choose one to see coverage details for that town.

• Irvine
• Kilmarnock
• Ayr
• Johnstone
• Barrhead
• All of Ayrshire

Other loading bay services in Kilwinning

• Cold store dock doorsThermally insulated dock doors for chilled and frozen loading bays.
• Dock bumpersRubber and steel-faced buffers that protect the dock face and leveller.
• Roller shutter loading bay doorsSteel or aluminium roller shutters for docks and goods-in openings.
• Dock traffic lights and interlocksRed and green signals and control interlocks for safe dock sequencing.
• Loading housesInsulated external dock pods with leveller and shelter built in.
• Loading bay conversions and upgradesTurn ground-level doors into docks or bring old bays up to date.

Full guide to edge-of-dock levellers · Everything we do in Kilwinning

Ready to talk about a loading bay in Kilwinning? Call us, or send the details through the quote form.