Dock traffic lights are red and green signals mounted outside and inside a loading bay to tell the driver and dock staff when it is safe to move or load. Interlocks are control links that stop equipment operating out of sequence, for example preventing the door opening until the trailer is restrained, or the leveller operating until the door is fully open.
How does this suit sites in Dundee and Angus?
Older docks in Dundee and Angus with separate door and leveller controls can be brought into a proper sequence by adding interlocks that stop equipment working out of order. Loading docks in Dundee and Angus where drivers wait in their cabs for a hand signal can replace guesswork with a clear red and green light at every bay.
If a site in Dundee and Angus has had door panels damaged by levellers raised too early, a leveller-to-door interlock is a straightforward fix to consider.
Step one is a survey at your site in Dundee and Angus, which costs nothing and carries no obligation. Step two is a written quote with a fixed price and a clear scope. Step three is installation, scheduled around your operation and carried out by specialist installation engineers working under our management, including evenings or weekends if agreed. Step four is handover, when the equipment is tested in front of you and the paperwork is passed over.
How much do dock traffic lights and interlocks cost?
Dock traffic lights and interlocks typically cost £650 to £3,400 per bay, supplied and fitted, excluding VAT. A pair of manually switched LED signals sits at the lower end, while a full interlock panel linking door, leveller, restraint and shelter sits towards the top.
What moves the price:
- Level of control: standalone lights, door-linked lights or a full interlocked sequence.
- Existing control panels: modern door and leveller panels often accept interlocks directly; older panels may need replacing with a combined bay panel.
- Sensors: door position switches, trailer presence sensors and restraint signals each add parts and wiring.
- Cable runs: distances between lights, panels and the power supply.
- Number of bays and timing: repeat bays reduce the cost per bay, while out-of-hours working adds to it.
These are guide budgets. After a free site survey we send a written quote, and that quote is the fixed price. VAT is added at the standard rate.
Which interlocks should a loading bay have?
The most useful loading bay interlocks stop the door opening until the trailer is in place or restrained, and stop the leveller operating until the door is fully open. Beyond that, the right set depends on the equipment fitted and your risk assessment.
- Door to restraint: the door cannot open until the restraint is engaged or a trailer is detected.
- Leveller to door: the leveller cannot be raised until the door is fully open, which prevents the lip hitting door panels.
- Door to leveller: the door cannot close until the leveller is back in its parked position.
- Restraint release: the restraint only releases once the door is closed and the leveller parked.
- Shelter to trailer: an inflatable shelter only inflates when a trailer is docked.
On a bay without a restraint, a trailer presence sensor can take its place in the door logic, although it confirms a trailer is there rather than holding it. Combining interlocks with vehicle restraints gives the strongest protection against drive-away.
Towns we cover in Dundee and Angus
We provide dock traffic lights and interlocks right across Dundee and Angus. Pick the town closest to your site from the list below.
Budget range for supply and fit. The written quote after a free survey is the fixed price. All guide prices.
Planning, building control and safety law in Scotland
HSE is the workplace safety regulator in Scotland. At a loading bay in Dundee and Angus, doors need to satisfy regulation 18 of the Workplace (Health, Safety and Welfare) Regulations 1992, dock equipment must be kept safe under PUWER, and drivers must be prevented from pulling away too early. We check what applies at survey.
Questions
Can you work outside our normal operating hours in Dundee and Angus?
Yes, by arrangement. Evening, night and weekend working can be planned so the installation causes as little disruption as possible to your loading schedule. Out-of-hours work can affect the price, so mention it at the survey and we will include it in the written quote. The agreed times are confirmed in the programme before the job starts.
What details do you need from us to quote for dock traffic lights and interlocks?
To get started, send the site address in Dundee and Angus, the number of bays or openings, approximate sizes, and photos of the dock from inside and outside. Tell us what vehicles you load, what goods you handle and any temperature requirements. Drawings help on new builds. We then arrange the free survey and confirm the details before the written quote is issued.
Which way round do the inside and outside lights work?
The inside and outside lights always show opposite colours. While a trailer is being loaded, the outside light is red so the driver stays put and the inside light is green so staff can work. When loading is finished and the door is closed, the inside light turns red and the outside light turns green for the driver.
Do traffic lights and interlocks need maintenance?
Yes. Lights, sensors and interlocks should be checked at each planned service visit, including testing the full sequence and confirming that steps attempted out of order are blocked. As part of the dock equipment they fall under PUWER, which requires work equipment to be maintained in a safe condition.
Other services in Dundee and Angus
Full guide to dock traffic lights and interlocks · All loading bay services in Dundee and Angus