- Location
- Calne, Wiltshire
- Main postcode district
- SN11
- Nearby (straight line)
- Chippenham (5 miles), Devizes (6 miles) and Melksham (7 miles)
- Visit pricing
- Agreed in writing before we attend
Dock shelter and seal repair covers restoring the weather seal around a docked trailer. Typical work includes replacing torn side and head curtains, worn foam seal pads and their covers, top pads and guide strips, repairing or replacing airbags and blowers on inflatable shelters, and straightening or replacing bent shelter frames, so the bay closes the gap between building and trailer again.
How does this suit sites in Calne?
Inflatable shelters at food sites in Calne depend on blowers and airbags working properly, and a slow-inflating shelter is worth checking before it fails. Curtains tearing at the corners at docks in Calne can be a sign that taller or wider trailers are arriving than the shelter was sized for.
Exposed yards in Calne that catch strong winds can tear shelter curtains or strain frames, letting weather into the dock until parts are replaced.
Repair and service visits in Calne are chargeable, and we agree the price with you in writing before anyone attends. Photos or a short video of the fault help us send the right engineer with the right parts. If the visit uncovers more work than expected, we quote it and wait for your approval before going ahead. After every visit you receive a written report on what was found and done.
How can I make shelter curtains and seal pads last longer?
Shelter curtains and seal pads last longest when trailers arrive straight, stop at the right distance and the parts are checked regularly. Most premature damage comes from how trailers are parked rather than from the material itself.
- Wheel guides: keep trailers centred so they do not drag one side curtain or crush one pad.
- Bumpers: worn bumpers let trailers reverse too far in and over-compress seals.
- Guide markings: clear centre lines on curtains and the dock help drivers line up.
- Early repairs: a small tear repaired early is cheaper than a full curtain later.
- Wear-resistant facings: seal pads can be specified with tougher covers where trailers rub most.
- Blower care: keeping blower intakes clear helps inflatable shelters inflate fully.
Our loading bay servicing includes shelters and seals, so wear is picked up alongside doors and levellers.
Should I repair my dock shelter or change to a different type?
Repair is usually right when the shelter or seal still suits your trailers and the damage is wear and tear. Changing type is worth considering when the same damage keeps recurring because the equipment no longer suits the vehicles arriving.
- Repair: curtains torn by normal use, worn pad covers, a failed blower or a single bent frame arm.
- Resize: head curtains or pads that are too short for taller trailers now in your fleet.
- Seal to shelter: foam seals suit consistent trailer sizes; a mixed fleet or curtain-siders may need a shelter instead.
- Retractable to inflatable: chilled or frozen docks that need a tighter seal around varied trailers.
- Frame type: shelters repeatedly bent by trailers may suit a retractable frame that gives on impact.
Any change of type is quoted separately from the repair. Our guide to dock shelters vs dock seals explains how each type works and which trailers it suits.
The visit price is agreed before anyone attends. Parts and any extra work are quoted before they are fitted.
What we look at around the bay
- Leveller toe guards and side skirting, where fitted
- Track alignment, rollers and wall fixings
- Vehicle restraint engagement and its signal sequence
- Dock bumpers for missing rubber or loose fixings
- Door panels, side seals and bottom rubbers
- Wiring, isolators and motor performance under load
Options to discuss
Frame repairs
Straightening or replacing bent arms, springs and frames on retractable shelters damaged by off-centre trailers, so the shelter returns square after each docking.
Curtain replacement
New side and head curtains for retractable shelters, made to measure in hard-wearing coated fabric, with slits and overlaps set to suit the trailers you receive.
Which rules apply in England?
Workplace safety in England is regulated by HSE. For a loading bay in Calne, that means doors meeting regulation 18 of the Workplace (Health, Safety and Welfare) Regulations 1992, equipment maintained under PUWER and suitable safeguards against vehicles driving away too early. We check what applies before any work starts and design the bay accordingly.
Questions about dock shelter and seal repairs in Calne
How often should equipment at our Calne site be serviced?
It depends on how hard the equipment works and on the manufacturer's recommendations. A multi-shift dock with frequent trailer movements needs more attention than a door that opens a few times a day. We suggest a schedule after looking at the equipment and how it is used, and we can line visits up with your insurance inspections where that helps.
How is a repair or service visit in Calne priced?
Repair and service visits are chargeable, and the price is agreed in writing before anyone attends. For dock shelter and seal repairs, the guide budget is £380 to £1,800 per repair, excluding VAT. The exact figure depends on the fault, parts, access and timing. If the engineer finds further work on the day, it is quoted for your approval before it is carried out.
What information helps before a repair visit?
Photos or a short video of the fault are the most useful thing you can send, along with the make and model from the data plate, a description of what happens when the equipment is operated and any error codes. For a site in Calne, also tell us about access, parking and site rules. With that, we can price the visit and bring the likely parts.
How is the price for a shelter or seal repair agreed?
You describe the damage and send photos, and we agree the visit price in writing before anyone attends. For made-to-measure parts that may include a measuring visit. Any extra work found on site is quoted and only carried out once you approve it.
Why do shelter curtains keep tearing?
Shelter curtains usually keep tearing because trailers arrive off-centre, the curtains are too short or tight for the trailers now in use, or worn bumpers let trailers reverse too far in. Fixing the cause, for example with wheel guides or resized curtains, stops repeat damage.
Dock shelter and seal repairs near Calne
Sites close to Calne get the same service, including those in Chippenham (5 miles), Devizes (6 miles) and Melksham (7 miles), with every job run the same way.
Other loading bay services in Calne
Full guide to dock shelter and seal repairs · Everything we do in Calne
Ready to talk about a loading bay in Calne? Call us, or send the details through the quote form.