- Location
- Manchester, Greater Manchester
- Main postcode districts
- M1, M2 and M15
- Nearby (straight line)
- Salford (2 miles), Stretford (4 miles) and Eccles (4 miles)
- Visit pricing
- Agreed in writing before we attend
Dock shelter and seal repair covers restoring the weather seal around a docked trailer. Typical work includes replacing torn side and head curtains, worn foam seal pads and their covers, top pads and guide strips, repairing or replacing airbags and blowers on inflatable shelters, and straightening or replacing bent shelter frames, so the bay closes the gap between building and trailer again.
What matters for dock shelter and seal repairs in Manchester?
Exposed yards in Manchester that catch strong winds can tear shelter curtains or strain frames, letting weather into the dock until parts are replaced. Repairs to shelters and seals in Manchester follow the same process as anywhere else in the UK, with the visit price agreed in writing first.
Chilled distribution sites around Manchester tend to notice failing seals quickly, as gaps around the trailer cause condensation and ice on the dock floor.
Servicing and repairs work slightly differently from installations. Visits to sites in Manchester are chargeable, and the price is set out in writing before anyone comes out. To help us prepare, send photos of the equipment and the fault. The engineer carries out the agreed work, flags anything else that needs attention and quotes it before touching it. Afterwards, a written report records the condition of each item.
Why is my dock shelter or seal letting in draughts?
A dock shelter or seal lets in draughts when the material that should press against the trailer is torn, worn, too short or no longer in the right place. Daylight around a docked trailer is the clearest sign.
- Torn or shrunk curtains: side curtains no longer overlap the trailer sides.
- Short head curtain: taller trailers than the shelter was sized for leave a gap across the top.
- Flattened seal pads: foam that has lost its spring no longer closes the gap.
- Worn pad covers: exposed foam soaks up water and breaks down faster.
- Bent frame: a retractable shelter frame that no longer returns square.
- Airbag or blower fault: inflatable shelters that inflate slowly or lose pressure.
- Trailer position: off-centre parking or worn bumpers that let trailers crush one side.
On chilled docks, gaps also show up as condensation, ice on the dock floor or frost around the door.
Do dock shelters and seals fall under PUWER?
Yes. Dock shelters and seals are work equipment under the Provision and Use of Work Equipment Regulations 1998 (PUWER), so they must be suitable, maintained in a safe condition and inspected where deterioration could lead to danger. In Northern Ireland the equivalent is PUWER (Northern Ireland) 1999.
Shelter and seal damage is often treated as a comfort or energy issue, but some faults are safety issues too:
- loose head curtains, top pads or fixings that could fall;
- bent or broken frame arms with sharp edges at head height;
- wet or icy dock floors caused by gaps around the trailer;
- electrical faults on inflatable shelter blowers.
The regulator is HSE in Great Britain and HSENI in Northern Ireland. Including shelters and seals in planned maintenance, and recording what is found, shows they are being kept in a safe condition. Problems found during servicing are quoted as repairs before any work is done.
The visit price is agreed before anyone attends. Parts and any extra work are quoted before they are fitted.
Checks made while we are on site
- Wiring, isolators and motor performance under load
- Safety edges, photocells and light curtains
- Dock bumpers for missing rubber or loose fixings
- Door springs, cables and drums for wear or damage
- Shelter curtains, frames and side pads for tears
- Track alignment, rollers and wall fixings
Options to discuss
Airbag and blower repairs
Repairing or replacing torn airbags, failed blower motors and controls on inflatable shelters so the bags inflate fully and seal around the trailer again.
Top pad and guide strip replacement
Renewing head pads, top seals and high-visibility guide strips that close the gap above the trailer and help drivers line up on the bay.
Regulations and approvals in England
Powered doors and dock equipment installed in England may carry the UKCA or the CE mark, and doors are covered by the product standard BS EN 13241. We hand over the relevant documentation for each item fitted in Manchester. Planning and Building Regulations questions are never assumed either way: we check what applies before any work starts, so you know before work is booked.
Questions about dock shelter and seal repairs in Manchester
How is a repair or service visit in Manchester priced?
Repair and service visits are chargeable, and the price is agreed in writing before anyone attends. For dock shelter and seal repairs, the guide budget is £380 to £1,800 per repair, excluding VAT. The exact figure depends on the fault, parts, access and timing. If the engineer finds further work on the day, it is quoted for your approval before it is carried out.
What information helps before a repair visit?
Photos or a short video of the fault are the most useful thing you can send, along with the make and model from the data plate, a description of what happens when the equipment is operated and any error codes. For a site in Manchester, also tell us about access, parking and site rules. With that, we can price the visit and bring the likely parts.
Can repairs be carried out outside our working hours?
Yes, by arrangement. Evening, night or weekend visits can be booked so that repairs and servicing at your Manchester site cause less disruption to loading. Out-of-hours attendance usually affects the price, so we include it when we agree the visit charge in writing. Tell us your shift pattern and the times when the dock is quietest.
Can you replace just the curtains on a dock shelter?
Yes. If the frame is still sound, the side and head curtains can be replaced on their own, which is the most common shelter repair. Curtains are usually made to measure, so the shelter is measured first and the new curtains fitted on a second visit, with both visits priced in advance.
Can worn dock seal covers be replaced without new foam?
Often, yes. If the foam inside a seal pad still springs back, a new cover can be fitted over it. If the foam has stayed compressed or soaked up water, the pad is usually replaced complete. Photos of the pads, front and side, help us judge which applies.
Dock shelter and seal repairs near Manchester
Businesses outside Manchester may find their nearest town in this list: Salford (2 miles), Stretford (4 miles) and Eccles (4 miles). Each page covers doors, docks, repairs and servicing.
Other loading bay services in Manchester
Full guide to dock shelter and seal repairs · Everything we do in Manchester
Get in touch about loading bay doors and dock equipment in Manchester: call, email or use the quote tool.