- Location
- Stroud, Gloucestershire
- Main postcode district
- GL5
- Nearby (straight line)
- Gloucester (8 miles), Cirencester (10 miles) and Cheltenham (12 miles)
- Visit pricing
- Agreed in writing before we attend
Dock shelter and seal repair covers restoring the weather seal around a docked trailer. Typical work includes replacing torn side and head curtains, worn foam seal pads and their covers, top pads and guide strips, repairing or replacing airbags and blowers on inflatable shelters, and straightening or replacing bent shelter frames, so the bay closes the gap between building and trailer again.
Where does this fit at a dock in Stroud?
Curtains tearing at the corners at docks in Stroud can be a sign that taller or wider trailers are arriving than the shelter was sized for. Exposed yards in Stroud that catch strong winds can tear shelter curtains or strain frames, letting weather into the dock until parts are replaced.
If tenants change at a unit in Stroud, checking the shelters and seals is sensible, because a new fleet may not suit the old curtain sizes.
Our repair process in Stroud has four parts. You describe the problem and send photos. We price the visit and confirm it in writing. The engineer attends, carries out the agreed work and quotes anything additional before doing it. You then receive a written report on the condition of the equipment and the work completed, which is useful for insurers, inspectors and your own planning.
Do dock shelters and seals fall under PUWER?
Yes. Dock shelters and seals are work equipment under the Provision and Use of Work Equipment Regulations 1998 (PUWER), so they must be suitable, maintained in a safe condition and inspected where deterioration could lead to danger. In Northern Ireland the equivalent is PUWER (Northern Ireland) 1999.
Shelter and seal damage is often treated as a comfort or energy issue, but some faults are safety issues too:
- loose head curtains, top pads or fixings that could fall;
- bent or broken frame arms with sharp edges at head height;
- wet or icy dock floors caused by gaps around the trailer;
- electrical faults on inflatable shelter blowers.
The regulator is HSE in Great Britain and HSENI in Northern Ireland. Including shelters and seals in planned maintenance, and recording what is found, shows they are being kept in a safe condition. Problems found during servicing are quoted as repairs before any work is done.
Should I repair my dock shelter or change to a different type?
Repair is usually right when the shelter or seal still suits your trailers and the damage is wear and tear. Changing type is worth considering when the same damage keeps recurring because the equipment no longer suits the vehicles arriving.
- Repair: curtains torn by normal use, worn pad covers, a failed blower or a single bent frame arm.
- Resize: head curtains or pads that are too short for taller trailers now in your fleet.
- Seal to shelter: foam seals suit consistent trailer sizes; a mixed fleet or curtain-siders may need a shelter instead.
- Retractable to inflatable: chilled or frozen docks that need a tighter seal around varied trailers.
- Frame type: shelters repeatedly bent by trailers may suit a retractable frame that gives on impact.
Any change of type is quoted separately from the repair. Our guide to dock shelters vs dock seals explains how each type works and which trailers it suits.
The visit price is agreed before anyone attends. Parts and any extra work are quoted before they are fitted.
Bay checks on a repair or service visit
- Shelter curtains, frames and side pads for tears
- Door panels, side seals and bottom rubbers
- Previous service and inspection records, where available
- Track alignment, rollers and wall fixings
- Door springs, cables and drums for wear or damage
- Vehicle restraint engagement and its signal sequence
Options to discuss
Curtain replacement
New side and head curtains for retractable shelters, made to measure in hard-wearing coated fabric, with slits and overlaps set to suit the trailers you receive.
Airbag and blower repairs
Repairing or replacing torn airbags, failed blower motors and controls on inflatable shelters so the bags inflate fully and seal around the trailer again.
Planning, building control and safety law in England
Workplace safety in England is regulated by HSE. For a loading bay in Stroud, that means doors meeting regulation 18 of the Workplace (Health, Safety and Welfare) Regulations 1992, equipment maintained under PUWER and suitable safeguards against vehicles driving away too early. We check what applies before any work starts and design the bay accordingly.
Questions about dock shelter and seal repairs in Stroud
What information helps before a repair visit?
Photos or a short video of the fault are the most useful thing you can send, along with the make and model from the data plate, a description of what happens when the equipment is operated and any error codes. For a site in Stroud, also tell us about access, parking and site rules. With that, we can price the visit and bring the likely parts.
What happens if the engineer finds the equipment unsafe?
If equipment is found to be unsafe, the engineer will tell you straight away and recommend that it is isolated and taken out of use until it is repaired. That is recorded in the written report. We then quote the repair so you can decide how to proceed. Keeping an unsafe door or leveller in service puts people at risk, so we will always raise it.
Can you repair all makes of loading bay equipment?
We work on common makes and types of doors, dock levellers, shelters, seals and restraints. Parts availability varies, particularly for older or discontinued equipment, so it helps to send the make, model and photos of any data plates from your site in Stroud. If original parts are not available, we tell you and price the alternatives, including replacement where that makes more sense.
Can repairs help a chilled loading bay?
Yes. Gaps around a docked trailer let chilled air escape and warm, moist air in, which causes condensation and ice on the dock floor. Restoring the curtains, pads or airbags closes those gaps, helping keep the dock drier and safer to work in.
How is the price for a shelter or seal repair agreed?
You describe the damage and send photos, and we agree the visit price in writing before anyone attends. For made-to-measure parts that may include a measuring visit. Any extra work found on site is quoted and only carried out once you approve it.
Dock shelter and seal repairs near Stroud
Nearby places we cover, measured from Stroud, include Gloucester (8 miles), Cirencester (10 miles) and Cheltenham (12 miles). Ask if your own town is missing.
Other loading bay services in Stroud
Full guide to dock shelter and seal repairs · Everything we do in Stroud
Send a few photos of the dock and a short description of the problem, and we will come back to you about your Stroud site.