- Location
- Dunoon, Argyll and Bute
- Main postcode district
- PA23
- Nearby (straight line)
- Greenock (6 miles), Helensburgh (8 miles) and Vale of Leven (13 miles)
- Visit pricing
- Agreed in writing before we attend
Dock leveller repair covers finding and fixing faults on the bridge between the dock and the trailer bed, including hydraulic cylinders, hoses and power packs, safety and check valves, lip hinges and lip cylinders, platform and lip damage, toe guards and control panels. It applies to swing-lip, telescopic-lip, mechanical and edge-of-dock levellers, with the aim of returning each one to safe working order.
Why do sites in Dunoon choose this?
Distribution docks in Dunoon that run several shifts put heavy cycles through leveller hydraulics, so leaks and slow operation can show up sooner. When a leveller at a warehouse near Dunoon sinks under load, it should be taken out of use until the hydraulic cause has been found and fixed.
Docks in Dunoon receiving trailers at widely varying bed heights can wear lip hinges faster, and hinge rebuilds are a routine part of leveller repair.
Every visit to a site in Dunoon begins with an agreed price. The charge is confirmed in writing before an engineer attends, so the cost is clear from the outset. Photos of the fault, the data plate and the surrounding area make diagnosis easier. Extra work found during the visit is priced and approved before it is done. A written report then sets out what was found, what was fixed and what still needs attention.
Can you repair defects listed on an insurer inspection report?
Yes. Repairing defects from an engineering insurer's inspection report is one of the most common reasons for a leveller repair visit. Sending us the report is the quickest way to get an accurate price.
How it works:
- Send the report: we read each defect against the leveller it refers to, with any photos you can add.
- Price each item: we agree the visit price in writing, listing the defects it covers.
- Repair: the engineer carries out the listed repairs, and any further defects found are quoted before work.
- Record: the written report shows which defects were cleared and how, which you can keep with the insurer's report.
Any re-inspection by the insurer is arranged between you and them. If a defect is marked as dangerous, the leveller should stay out of use until it has been repaired.
Grouping several levellers' defects into one visit usually keeps the cost per item down.
What happens on site during a dock leveller repair?
During a leveller repair the bay is closed, the leveller is isolated and propped, and the engineer works from the pit or deck to diagnose and repair the fault. Neighbouring bays normally keep working.
- Close the bay: no trailer on the dock, the door closed and forklifts kept away.
- Isolate and prop: the leveller is electrically isolated and locked off, and the platform raised and supported on its maintenance strut before anyone goes underneath.
- Clean and inspect: debris and spilt oil are cleared from the pit so the fault can be traced.
- Repair: parts are fitted or welded. Anything beyond the agreed scope is quoted first.
- Test: the leveller is cycled, the lip checked and controls tested before the bay reopens.
It helps if you can provide a clear bay, a contact on site, photos or labels showing the leveller type and size, and any insurer inspection report that lists the defect.
The visit price is agreed before anyone attends. Parts and any extra work are quoted before they are fitted.
Checks made while we are on site
- Leveller toe guards and side skirting, where fitted
- Wiring, isolators and motor performance under load
- Shelter curtains, frames and side pads for tears
- Safety edges, photocells and light curtains
- Vehicle restraint engagement and its signal sequence
- Anti-fall device on upward-opening doors
Options to discuss
Control and safety repairs
Control panels, push buttons, limit switches, maintenance struts, toe guards and side skirts repaired or replaced so the leveller operates and parks safely.
Lip and hinge repairs
Seized or worn lip hinges rebuilt, hinge pins replaced, bent lips straightened or replaced, and lip cylinders repaired so the lip extends fully on to the trailer bed.
Which rules apply in Scotland?
Lift tables at Scottish sites are lifting equipment under LOLER, which means thorough examination at least every 12 months, or every 6 months if people are lifted, depending on the equipment and its use. For a site in Dunoon, your insurer or competent person will confirm the interval, and we check what applies before any work starts.
Repair and service visits to Dunoon are covered by arrangement. Travel and any overnight stay are included in the visit price we agree with you in writing beforehand, and we group visits with other work nearby where we can.
Questions about dock leveller repairs in Dunoon
What happens if the engineer finds the equipment unsafe?
If equipment is found to be unsafe, the engineer will tell you straight away and recommend that it is isolated and taken out of use until it is repaired. That is recorded in the written report. We then quote the repair so you can decide how to proceed. Keeping an unsafe door or leveller in service puts people at risk, so we will always raise it.
How often should equipment at our Dunoon site be serviced?
It depends on how hard the equipment works and on the manufacturer's recommendations. A multi-shift dock with frequent trailer movements needs more attention than a door that opens a few times a day. We suggest a schedule after looking at the equipment and how it is used, and we can line visits up with your insurance inspections where that helps.
What is the difference between servicing and a statutory inspection?
Servicing keeps equipment working: cleaning, adjusting, lubricating and replacing worn parts. A statutory inspection or thorough examination is a separate check by a competent person, often arranged through your engineering insurer. Dock levellers are commonly inspected under PUWER at 12-month intervals, and lift tables may need LOLER thorough examination, depending on the equipment and how it is used. Your insurer or competent person will confirm what applies.
Can a leveller be repaired without disturbing the pit?
Usually yes. Most leveller repairs are carried out in place, working from the deck or from the pit with the platform propped. If the pit itself is cracked, broken at the edges or holding water, that is noted in the report and any pit repair is priced separately.
How is the price for a leveller repair agreed?
You describe the fault and send photos, and we agree the visit price in writing before anyone attends. If the engineer finds more work is needed, it is quoted and only carried out once you approve it. The visit is chargeable, and the price is always agreed first.
Dock leveller repairs near Dunoon
Looking beyond Dunoon? Our pages for Greenock (6 miles), Helensburgh (8 miles) and Vale of Leven (13 miles) describe the same loading bay services and how to get in touch.
Other loading bay services in Dunoon
Full guide to dock leveller repairs · Everything we do in Dunoon
Start your enquiry for Dunoon through the quote tool. A few photos and approximate sizes help us respond with something useful.