- Location
- Chichester, West Sussex
- Main postcode district
- PO19
- Nearby (straight line)
- Bognor Regis (6 miles), Emsworth (7 miles) and Havant (9 miles)
- Survey and quote
- Free, with a fixed written quote
A cold store dock door is an insulated loading bay door built for chilled or frozen buildings, usually a sectional door with thick insulated panels or a high-speed door with an insulated curtain. It differs from a standard dock door in its thermal breaks, extra seals and, on freezer docks, heating in the frame or seals so that ice cannot lock the door shut or tear the seals.
What matters for cold store dock doors in Chichester?
Converting an ambient unit in Chichester to chilled storage usually means replacing standard dock doors with insulated ones and sealing around the trailers. Pharmaceutical and healthcare stores around Chichester with tight temperature ranges can pair an insulated dock door with interlocks so the opening stays closed until a trailer is sealed.
When an older cold store in Chichester has a door that has been repaired many times, a planned replacement can be timed for a quieter trading period.
We never ask you to commit before you have a fixed price. A free survey at your Chichester site comes first, followed by a written quote. When the order goes ahead, we plan the installation around your operation, book any out-of-hours working you need and manage the specialist installation engineers on site. The job ends with a full test, a run-through for the people who will use the equipment and a set of handover documents.
Do cold store dock doors have to meet building regulations?
Yes, a new or replacement cold store dock door is still a vehicle access door, so building energy rules apply alongside workplace safety law and product standards.
- England: Approved Document L (2021) Volume 2 limits the U-value of vehicle access and similar large doors to 1.3 W/m²K in new and replacement work. Cold store doors are normally specified to perform better than that to protect the store.
- Wales, Scotland and Northern Ireland: Approved Document L for Wales, Section 6 of the Scottish Building Standards Technical Handbook and Technical Booklet F2 in Northern Ireland apply. We confirm the figure for your nation and project.
- Power failure: under the Workplace (Health, Safety and Welfare) Regulations 1992 in Great Britain, or the 1993 Northern Ireland regulations, a powered door must be operable by hand where needed for health or safety, unless it opens automatically when power fails.
- Standards: BS EN 13241 for the door and BS EN 12453 for powered operation.
How can a cold store door be replaced without losing temperature?
A cold store door can be replaced with very little temperature loss if the work is planned around the store, with the opening screened and the fitting done in one continuous visit.
On a live cold store we usually:
- schedule the work for the quietest period, often overnight or at a weekend,
- fit a temporary insulated screen or strip curtain while the opening is exposed,
- remove ice from the old frame and threshold before fixing the new door,
- pre-assemble as much as possible so the opening is exposed for the shortest time.
From your side we need product moved back from the opening, any site permits for working in cold areas, and power for the operator and frame heaters. Heated frames typically need their own supply, which we set out in the quote. Our cold store loading bays guide covers planning the work in more depth.
The same published guide range applies across England; access, out-of-hours working and site conditions are confirmed at the free survey.
What do we check at the survey?
- Traffic routes for vehicles and separation of pedestrians
- How often each door cycles during a typical shift
- Forklift and pallet truck loads crossing the leveller platform
- Dock height and the mix of trailers you load
- Yard gradient and the slope of the approach to the dock
- Temperature requirements for chilled, frozen or ambient goods
Options to discuss
Insulated sectional cold store door
Thick insulated panels with thermal breaks and full perimeter seals, the usual choice for chilled and frozen external dock openings that also need to be secure overnight.
Heated frames and seals
Low-power heating in the side frames, bottom seal or threshold that keeps contact surfaces above freezing so the door does not ice up or tear its seals.
What do the rules in England mean for the work?
In England, Approved Document L (2021) sets a limiting U-value of 1.3 W/m²K for vehicle access and similar large doors in new and replacement work. That shapes door specification for sites in Chichester, so we confirm the requirement for your project and check what applies at survey before recommending a door.
Questions about cold store dock doors in Chichester
What warranty comes with new loading bay equipment?
New equipment comes with the manufacturer's warranty, which varies by product. Our workmanship terms are set out in writing in the quote for your Chichester site, so you can see what is covered before you commit. Check the warranty terms for any servicing conditions, and we can quote for planned maintenance once the installation is complete.
Will you deal with building control and planning for a project in Chichester?
We check at survey whether the work is likely to need approval. Forming a new opening or dock pit may need Building Regulations approval, a building warrant or building control approval, depending on the nation, and external structures such as loading houses can need planning permission. Where approval is needed, we explain what is involved, work with your designer or agent, and build it into the programme.
What details do you need from us to quote for cold store dock doors?
To get started, send the site address in Chichester, the number of bays or openings, approximate sizes, and photos of the dock from inside and outside. Tell us what vehicles you load, what goods you handle and any temperature requirements. Drawings help on new builds. We then arrange the free survey and confirm the details before the written quote is issued.
What happens to a cold store door in a power cut?
In a power cut the door stops where it is and the frame heating switches off, so it must be possible to operate the door by hand. Powered dock doors normally have a hand chain, crank or release for this. We show your team how to use it at handover so the store can be closed up quickly.
Can a cold store door be paired with a high-speed door?
Yes, cold store docks often pair an insulated sectional door on the outside with a fast door just inside it, or use an insulated high-speed door as the only door between zones. The right arrangement depends on traffic, security and how much space there is around the opening.
Cold store dock doors near Chichester
If your site is not in Chichester itself, it may be near one of these: Bognor Regis (6 miles), Emsworth (7 miles) and Havant (9 miles). Pick the closest.
Other loading bay services in Chichester
Full guide to cold store dock doors · Everything we do in Chichester
Have photos of the door, leveller or shelter? Send them with your enquiry and we can give a clearer answer for your Chichester site.