A cold store dock door is an insulated loading bay door built for chilled or frozen buildings, usually a sectional door with thick insulated panels or a high-speed door with an insulated curtain. It differs from a standard dock door in its thermal breaks, extra seals and, on freezer docks, heating in the frame or seals so that ice cannot lock the door shut or tear the seals.
Why do sites in Somerset choose this?
Any cold store dock survey in Somerset is carried out with the store running, so we can see ice, seals and traffic as they really are. Pharmaceutical and healthcare stores around Somerset with tight temperature ranges can pair an insulated dock door with interlocks so the opening stays closed until a trailer is sealed.
During warm, humid spells, any cold store dock in Somerset is most exposed to condensation and ice, which is why heated frames and good shelters are worth considering.
A single contact at Loading Bay Doors handles your project in Somerset from start to finish. The free site survey and fixed written quote come first, with no obligation to proceed. We then book the installation for times that suit the operation, including out of hours by arrangement, and manage the specialist engineers on site. At the end we commission and test the equipment, walk your team through it and provide the documentation.
Do cold store dock doors have to meet building regulations?
Yes, a new or replacement cold store dock door is still a vehicle access door, so building energy rules apply alongside workplace safety law and product standards.
- England: Approved Document L (2021) Volume 2 limits the U-value of vehicle access and similar large doors to 1.3 W/m²K in new and replacement work. Cold store doors are normally specified to perform better than that to protect the store.
- Wales, Scotland and Northern Ireland: Approved Document L for Wales, Section 6 of the Scottish Building Standards Technical Handbook and Technical Booklet F2 in Northern Ireland apply. We confirm the figure for your nation and project.
- Power failure: under the Workplace (Health, Safety and Welfare) Regulations 1992 in Great Britain, or the 1993 Northern Ireland regulations, a powered door must be operable by hand where needed for health or safety, unless it opens automatically when power fails.
- Standards: BS EN 13241 for the door and BS EN 12453 for powered operation.
Why does ice form around a freezer dock door, and how is it stopped?
Ice forms when warm, moist outside air meets the cold surfaces of the door, frame and floor, and the moisture freezes. Over time it builds up in the seals and guides until the door jams or tears its seals.
Ice is controlled by tackling both the cold surfaces and the warm air:
- Heated frames and seals: low-power heating in the side frames and bottom seal keeps those surfaces above freezing.
- Threshold heating: stops the door freezing to the floor.
- A tight seal at the trailer: an inflatable dock shelter or a well-fitted seal keeps outside air away from the opening.
- Short open times: fast operators and interlocks mean the door is only open while a trailer is sealed to the dock.
Condensation dripping inside the store near the door is an early sign of the same problem and worth raising at survey.
Towns we cover in Somerset
Find your town in the list below for details of cold store dock doors across Somerset, or contact us if your location is not shown.
Budget range for supply and fit. The written quote after a free survey is the fixed price. All guide prices.
What do the rules in England mean for the work?
Powered doors and dock equipment installed in England may carry the UKCA or the CE mark, and doors are covered by the product standard BS EN 13241. We hand over the relevant documentation for each item fitted in Somerset. Planning and Building Regulations questions are never assumed either way: we check what applies at survey, so you know before work is booked.
Questions
Can you work outside our normal operating hours in Somerset?
Yes, by arrangement. Evening, night and weekend working can be planned so the installation causes as little disruption as possible to your loading schedule. Out-of-hours work can affect the price, so mention it at the survey and we will include it in the written quote. The agreed times are confirmed in the programme before the job starts.
Do you cover Somerset for cold store dock doors?
Yes. We take on cold store dock doors for businesses in Somerset and across Somerset. We survey the site, provide a fixed written quote and manage the installation, with specialist installation engineers working under our management. Visits are arranged in advance at a time that suits your operation, and the same single contact stays with the job through to handover.
Do cold store doors need more frequent servicing?
Yes, cold store doors generally benefit from more frequent servicing than ambient dock doors. Low temperatures stiffen seals, stress springs and cables, and hide early ice build-up. Checking heaters, seals and operator settings before winter is particularly worthwhile. Servicing visits are chargeable and agreed in advance.
Can a cold store door be paired with a high-speed door?
Yes, cold store docks often pair an insulated sectional door on the outside with a fast door just inside it, or use an insulated high-speed door as the only door between zones. The right arrangement depends on traffic, security and how much space there is around the opening.
Other services in Somerset
Full guide to cold store dock doors · All loading bay services in Somerset