- Location
- Ramsgate, Kent
- Main postcode district
- CT11
- Nearby (straight line)
- Broadstairs (2 miles), Margate (3 miles) and Deal (8 miles)
- Survey and quote
- Free, with a fixed written quote
A cold store dock door is an insulated loading bay door built for chilled or frozen buildings, usually a sectional door with thick insulated panels or a high-speed door with an insulated curtain. It differs from a standard dock door in its thermal breaks, extra seals and, on freezer docks, heating in the frame or seals so that ice cannot lock the door shut or tear the seals.
Is this right for your site in Ramsgate?
For a packhouse in Ramsgate handling fresh produce, a well-sealed chilled dock door helps keep warm air out of the store once produce has been cooled. A chilled distribution centre in Ramsgate opens its dock doors many times a shift, so the door specification matters far more than at an ambient bay.
During warm, humid spells, any cold store dock in Ramsgate is most exposed to condensation and ice, which is why heated frames and good shelters are worth considering.
If you are planning cold store dock doors for a site in Ramsgate, expect four stages. A free survey and fixed written quote come first. We then agree a programme with you, including any out-of-hours work. Specialist installation engineers carry out the installation under our management, with us as your single point of contact. Finally, the equipment is tested, your staff are shown how it works and everything is handed over with its documentation.
Do cold store dock doors have to meet building regulations?
Yes, a new or replacement cold store dock door is still a vehicle access door, so building energy rules apply alongside workplace safety law and product standards.
- England: Approved Document L (2021) Volume 2 limits the U-value of vehicle access and similar large doors to 1.3 W/m²K in new and replacement work. Cold store doors are normally specified to perform better than that to protect the store.
- Wales, Scotland and Northern Ireland: Approved Document L for Wales, Section 6 of the Scottish Building Standards Technical Handbook and Technical Booklet F2 in Northern Ireland apply. We confirm the figure for your nation and project.
- Power failure: under the Workplace (Health, Safety and Welfare) Regulations 1992 in Great Britain, or the 1993 Northern Ireland regulations, a powered door must be operable by hand where needed for health or safety, unless it opens automatically when power fails.
- Standards: BS EN 13241 for the door and BS EN 12453 for powered operation.
How can a cold store door be replaced without losing temperature?
A cold store door can be replaced with very little temperature loss if the work is planned around the store, with the opening screened and the fitting done in one continuous visit.
On a live cold store we usually:
- schedule the work for the quietest period, often overnight or at a weekend,
- fit a temporary insulated screen or strip curtain while the opening is exposed,
- remove ice from the old frame and threshold before fixing the new door,
- pre-assemble as much as possible so the opening is exposed for the shortest time.
From your side we need product moved back from the opening, any site permits for working in cold areas, and power for the operator and frame heaters. Heated frames typically need their own supply, which we set out in the quote. Our cold store loading bays guide covers planning the work in more depth.
The same published guide range applies across England; access, out-of-hours working and site conditions are confirmed at the free survey.
What we look at on site
- Control positions, isolators and any existing interlocks
- Wheel guide positions and yard markings for reversing vehicles
- Gaps around trailers where heated or chilled air escapes
- Power supply at each bay, including three-phase availability
- Bumper position and wear or damage on the dock face
- Traffic routes for vehicles and separation of pedestrians
Options to discuss
Insulated sectional cold store door
Thick insulated panels with thermal breaks and full perimeter seals, the usual choice for chilled and frozen external dock openings that also need to be secure overnight.
Dock interlocks
Controls that link the door to the shelter, leveller and restraint so the door only opens when a trailer is docked and sealed against the building.
What do the rules in England mean for the work?
Powered doors and dock equipment installed in England may carry the UKCA or the CE mark, and doors are covered by the product standard BS EN 13241. We hand over the relevant documentation for each item fitted in Ramsgate. Planning and Building Regulations questions are never assumed either way: we check what applies at survey, so you know before work is booked.
Questions about cold store dock doors in Ramsgate
Will you deal with building control and planning for a project in Ramsgate?
We check at survey whether the work is likely to need approval. Forming a new opening or dock pit may need Building Regulations approval, a building warrant or building control approval, depending on the nation, and external structures such as loading houses can need planning permission. Where approval is needed, we explain what is involved, work with your designer or agent, and build it into the programme.
Do you remove and dispose of the old equipment?
Yes, where it is part of the scope. When we replace doors, levellers, shelters or seals at a site in Ramsgate, removal and disposal of the old equipment can be included and is itemised in the quote, so it is clear what is covered. If anything should be kept, such as a frame or motor that is still serviceable, we agree that at survey.
Can you work outside our normal operating hours in Ramsgate?
Yes, by arrangement. Evening, night and weekend working can be planned so the installation causes as little disruption as possible to your loading schedule. Out-of-hours work can affect the price, so mention it at the survey and we will include it in the written quote. The agreed times are confirmed in the programme before the job starts.
Can a standard sectional door be used on a chilled dock?
A standard insulated sectional door can work on a chilled dock if its panels are thick enough and its seals are in good condition. For frozen docks it is not usually suitable, because it lacks the thermal breaks and frame heating needed to stop ice forming. We advise on the right specification after surveying the store.
What happens to a cold store door in a power cut?
In a power cut the door stops where it is and the frame heating switches off, so it must be possible to operate the door by hand. Powered dock doors normally have a hand chain, crank or release for this. We show your team how to use it at handover so the store can be closed up quickly.
Cold store dock doors near Ramsgate
The same survey, quote and repair service is available in towns around Ramsgate, such as Broadstairs (2 miles), Margate (3 miles) and Deal (8 miles).
Other loading bay services in Ramsgate
Full guide to cold store dock doors · Everything we do in Ramsgate
For a written price on loading bay work in Ramsgate, request a quote and include photos of the bay if you can.