- Location
- Gillingham, Kent
- Main postcode district
- ME7
- Nearby (straight line)
- Chatham (1 mile), Rochester (2 miles) and Strood (3 miles)
- Survey and quote
- Free, with a fixed written quote
A cold store dock door is an insulated loading bay door built for chilled or frozen buildings, usually a sectional door with thick insulated panels or a high-speed door with an insulated curtain. It differs from a standard dock door in its thermal breaks, extra seals and, on freezer docks, heating in the frame or seals so that ice cannot lock the door shut or tear the seals.
How does this suit sites in Gillingham?
During warm, humid spells, any cold store dock in Gillingham is most exposed to condensation and ice, which is why heated frames and good shelters are worth considering. A chilled distribution centre in Gillingham opens its dock doors many times a shift, so the door specification matters far more than at an ambient bay.
Converting an ambient unit in Gillingham to chilled storage usually means replacing standard dock doors with insulated ones and sealing around the trailers.
We keep the process simple for sites in Gillingham. A free survey tells us what the dock needs; a fixed written quote tells you what it will cost and what is included. We then organise the installation, with specialist engineers under our management and a programme agreed around your shifts. Night and weekend work is available by arrangement. Before we leave, the new equipment is tested, demonstrated and handed over with its documentation.
How can a cold store door be replaced without losing temperature?
A cold store door can be replaced with very little temperature loss if the work is planned around the store, with the opening screened and the fitting done in one continuous visit.
On a live cold store we usually:
- schedule the work for the quietest period, often overnight or at a weekend,
- fit a temporary insulated screen or strip curtain while the opening is exposed,
- remove ice from the old frame and threshold before fixing the new door,
- pre-assemble as much as possible so the opening is exposed for the shortest time.
From your side we need product moved back from the opening, any site permits for working in cold areas, and power for the operator and frame heaters. Heated frames typically need their own supply, which we set out in the quote. Our cold store loading bays guide covers planning the work in more depth.
How should a door be specified for a chilled dock compared with a freezer dock?
A chilled dock needs a well-insulated, well-sealed door, while a freezer dock also needs heating to stop ice forming in the frame and seals. The temperature difference across the door drives most specification choices.
- Chilled docks: an insulated sectional door at the thicker end of the common 40 to 80 mm panel range, good perimeter seals and a shelter or seal outside usually do the job.
- Freezer docks: thick panels, thermal breaks in the panel joints, heated side frames and a heated bottom seal, plus a fast operator to cut open time.
- Doors between zones: an insulated high-speed door often suits openings between a chilled marshalling area and a freezer, where traffic is constant.
- Vision panels: possible, but they reduce insulation and can mist, so many freezer docks leave them out.
A cold store door is only as good as the seal around the trailer, which is why we specify the door, shelter and leveller together.
The same published guide range applies across England; access, out-of-hours working and site conditions are confirmed at the free survey.
What do we check at the survey?
- Scope to convert ground-level doors into docks or add lift tables
- Working hours, shift patterns and windows for out-of-hours work
- Whether planning, building control or a building warrant may be needed
- Traffic routes for vehicles and separation of pedestrians
- Dock height and the mix of trailers you load
- Headroom above the opening and which track type will suit it
Options to discuss
Insulated high-speed door
A fast door with an insulated curtain for busy openings between temperature zones, where cutting open time matters more than maximum insulation.
Heated frames and seals
Low-power heating in the side frames, bottom seal or threshold that keeps contact surfaces above freezing so the door does not ice up or tear its seals.
Planning, building control and safety law in England
In England, Approved Document L (2021) sets a limiting U-value of 1.3 W/m²K for vehicle access and similar large doors in new and replacement work. That shapes door specification for sites in Gillingham, so we confirm the requirement for your project and check what applies at survey before recommending a door.
Questions about cold store dock doors in Gillingham
What details do you need from us to quote for cold store dock doors?
To get started, send the site address in Gillingham, the number of bays or openings, approximate sizes, and photos of the dock from inside and outside. Tell us what vehicles you load, what goods you handle and any temperature requirements. Drawings help on new builds. We then arrange the free survey and confirm the details before the written quote is issued.
Can you work outside our normal operating hours in Gillingham?
Yes, by arrangement. Evening, night and weekend working can be planned so the installation causes as little disruption as possible to your loading schedule. Out-of-hours work can affect the price, so mention it at the survey and we will include it in the written quote. The agreed times are confirmed in the programme before the job starts.
Can you work alongside our main contractor on a new build in Gillingham?
Yes. For new warehouses and fit-outs, we can supply and install the dock package as part of a wider project, working to the main contractor's programme, site rules and permits. We will need drawings, dock levels and the programme, and we coordinate pit details, power supplies and door openings with the relevant trades before installation begins.
Can a cold store door be paired with a high-speed door?
Yes, cold store docks often pair an insulated sectional door on the outside with a fast door just inside it, or use an insulated high-speed door as the only door between zones. The right arrangement depends on traffic, security and how much space there is around the opening.
What happens to a cold store door in a power cut?
In a power cut the door stops where it is and the frame heating switches off, so it must be possible to operate the door by hand. Powered dock doors normally have a hand chain, crank or release for this. We show your team how to use it at handover so the store can be closed up quickly.
Cold store dock doors near Gillingham
Sites close to Gillingham get the same service, including those in Chatham (1 mile), Rochester (2 miles) and Strood (3 miles), with every job run the same way.
Other loading bay services in Gillingham
Full guide to cold store dock doors · Everything we do in Gillingham
Ready to talk about a loading bay in Gillingham? Call us, or send the details through the quote form.